Loading ...
Loading ...
Loading ...
• The rope guide is attached to the right side of upper
handle. Loosen the wing nut which secures the
rope guide. See Figure 4.
• With spark plug wire disconnected and grounded,
hold the blade control handle against the upper
handle, and pull the starter rope out of the engine.
Release blade control handle. Slip the rope into the
rope guide. Tighten the wing nut. See Figure 4.
• Tighten all nuts and bolts securely.
• Attach the cables to the lower handle with the two
cable ties already on the lower handle. Pull tight the
cable ties and cut off the extra
Hardtop GrassBag
Parts for Hardtop Grass Bag:
1. Front Frame
2. Rear Frame (packed inside hardtop cover)
3. Bag
4. Hardtop Cover
5. Mounting Bracket
6. Phillips Screw
7. Hex Lock Nut
Slit
/
Slip rope,into
rope g._a_R
Guide '_
Wing Nut
Figure 4
AssemblingGrassCatcher
NOTE: Make certain bag is turned right side out before
assembling (warning label will be on the outside).
SoftGrassBag
Parts for Soft Grass Bag:
1. Front Frame & Rear Frame
2. Bag
Assemble soft grass bag as follows:
• Join the rear frame and front frame assembly as
shown in Figure 5A.
• Place bag over frame (black plastic side is the
bottom of bag). Slip the openings inthe side of the
plastic channel on bag over the hooks on the grass
catcher frame.
• Secure bag to frame by working the plastic
channels on bag over frame as shown in Figure 5B.
All of the plastic channels except center top of bag
attach from the outside of bag. Center top of bag
attaches from the inside of bag.
A
Front
Frame
Assembly
Rear
Figure 6
Assemble hard top grass bag as follows:
• Insert one end of the rear frame into the slit in the
cloth channel on the edge of the grass bag (slits are
approximately 6 inches from the end of the bag).
See Figure 6. Feed all the material on one side of
the frame before working it around frame. Make
certain the other end of rear frame comes out the
slit in the other side.
• Slide the ends of the front frame assembly into the
ends of the rear frame as shown in Figure 7. The
handle in front frame assembly goes away from the
black plastic bottom of the bag. Push the two
frames together until the cross piece on the front
frame contacts the rear frame.
Front Frame
J
channe
over frame I
Figure 5
Plastic
Channels
Figure 7
Slip the openings in the side of the plastic channel
on bag over hooks on the grass catcher frame. See
Figure 7 inset.
Loading ...
Loading ...
Loading ...