Loading ...
Loading ...
Loading ...
• Before reassembling the blade and the blade
adapter to the unit, lubricate the engine crankshaft
and the inner surface of the blade adapter with light
oil (or engine oil). Also lubricate the bolt holes, bolts
and inner surface of the nuts.
• Install the blade adapter on the crankshaft with the
"star" away from the engine. Refer to Figure 18.
Place the blade with the side marked bottom (or
with part number) facing away from the adapter.
• Align the blade bell support over the blade with the
tabs in the holes of the blade and insert the hex
bolt. Tighten the hex bolt to the torque listed in the
"Blade Mounting Torque" section below.
BladeMountingTorque
Center Bolt: 450 in. Ibs. min., 600 in. Ibs. max.
IMPORTANT:Toensure safe operation, all nuts and
bolts must be checked periodically for correct tightness.
DeckCare
NOTE: We do not recommend the use of pressure
washers or garden hose to clean your unit. These may
cause damage to electric components spindles,
pulleys, bearings or the engine. The use of water will
shorten life of the mower and reduce its serviceability.
The underside of the mower deck should be
cleaned after each use to prevent a buildup of
grass clippings, leaves, dirt or other matter. If this
debris is allowed to accumulate, it will invite rust
and corrosion, and may cause an uneven
discharge of grass clippings at the next cutting.
• The deck may be cleaned by tilting the mower and
scraping clean with a suitable tool (make certain the
spark plug wire is disconnected).
Engine
• Refer to the separate engine manual.
ReplacingRearFlap
• To remove rear flap, cut off the flat end of the wire
rod which secures itto the deck. See Figure 20.
• Attach the new flap and new rod to deck, bending
the ends of the new rod over to secure to deck.
Handle
Bracket
\\,
Rear Discharge
Door
\,
\
\
Rear
Flap
Handle
Bracket
Figure 20
SECTION8: OFF-SEASONSTORAGE
The following steps should be taken to prepare lawn
mower for storage.
• Clean and lubricate mower thoroughly as described
in the lubrication instructions.
• Refer to engine manual for correct engine storage
instructions.
• Coat mower's cutting blade with chassis grease to
prevent rusting.
• Store mower in a dry, clean area. Do not store next
to corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rust-proof the equipment. Using a light oil or
silicone, coat the equipment, especially cables and all
moving parts.
15
Loading ...
Loading ...
Loading ...