Loading ...
Loading ...
Loading ...
8
ASSEMBLY INSTRUCTIONS
Glass Bowl
13. Feed the pull chain coming from the center of the light
kit through the center hole in the glass bowl and feed the
pull chain coming from the switch housing through the
o-center hole in the glass bowl. Lift the glass bowl onto
the threaded rod at the bottom of the light kit. Lift the
nial cap until it is ush with the glass bowl and secure
with the nial.
Note: Ensure the pull chain from the switch housing is
aligned with the o-center hole in the glass bowl and
the o-center hole in the nial cap to ensure smooth pull
chain operation.
Proceed to Step 16.
Finial
Finial Cap
O-Center Hole
13
Single-pin Connector
Lock Washer
Hex Nut
Notch
Reverse
Switch
Plug Button
Switch Housing Cap
Switch Housing
Screw
Switch
Housing
Pull Chain
Extension
16
14
15
14. To install the fan without the light kit, disconnect
the single-pin connectors inside of the switch housing.
Then, remove the preassembled hex nut and lock washer
from the threaded rod on the inside of the switch housing.
Remove light kit from the switch housing and install the
plug button into the center hole of the switch housing.
16. Attach pull chain extensions to the pull chains.
15. Remove the three switch housing screws from the
switch housing cap. Then, attach the switch housing cap
to the switch housing using the switch housing screws.
Note: Align the notch in the switch housing cap with the
reverse switch.
Restore the power at the main fuse or circuit breaker and
wall switch.
Assembly is complete.
Loading ...
Loading ...
Loading ...