Loading ...
Loading ...
Loading ...
7
ASSEMBLY INSTRUCTIONS
Motor Screw
Blade Arm
9. Install the blade arm to the underside of the motor
assembly with motor screws previously removed (Step 3,
page 5). Tighten with Phillips screwdriver (not included).
Repeat for each blade arm.
9
Bulb
Switch
Housing Cap
Notch
Light Kit
Light Kit
Single-pin
Connector
Switch
Housing
Screw
Reverse
Switch
Threaded Rod
Light Kit
Finial
Finial Cap
10
11
12
12. Remove the preassembled nial and nial cap from
threaded rod on the light kit.
11. Install the E26-base LED bulbs into the sockets of the
light kit.
Important: Make sure you allow the bulbs and light kit to
cool before you replace the bulbs.
10. Remove the three switch housing screws from the
top edge of the switch housing cap. Connect the single-
pin connectors from the switch housing to the single-pin
connectors from the light kit -- blue to black and white to
white. Secure the light kit to the switch housing with the
three switch housing screws.
Note: Align the notch in the switch housing cap with the
reverse switch on the switch housing.
Loading ...
Loading ...
Loading ...