Loading ...
Loading ...
Loading ...
Assembly of the Surface Burner Heads, Burner Caps and Burner Grates (Porcelain & Stainless
Steel Cooktop models)
it is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates are
installed correctly and at the correct locations,
1, Remove all packing tape from cooktop area, Remove all Burner Caps and Burner Heads,
2, Discard all packing material located under Burner Heads (if applicable),
3, To replace the Burner Heads & Caps, match the letters located under center of Burner
Caps with the letters located inside Burner Heads (Figure 1),
4, Match Burner Skirts (some models) or the emboss on the cooktop with Burner Heads and
Burner
Burner Caps (see Figure 1), Replace the Burner Heads and Caps on cooktop (see Figure Cap
2), Carefully align the Electrodes into slot or hole of each Burner Head (Figure 3), Note:
The Burner Heads should sit flat on Cooktop Burner Skirts,
5, Unpack Burner Grates and position on the cooktop,
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
ORIFICE HOLDER OPENING. Always keep the Burner Caps and
Burner Heads in place whenever the surface burners are in use,
Figure 2
Figure 1
Assembly of the Surface Burner Heads, Burner Caps and Burner Grates (Ceramic G_ass
Cooktop mode_s)
It is very important to make sure that all of the Surface Burner
Heads, Surface Burner Caps and Surface Burner Grates are
installed correctly and at the correct locations,
1, Be sure to follow the Installation Instructions before installing
and using you r new cooktop, Electrodes must
a gn nto sot or Burner
2, Remove all packing tape from cooktop, Remove Burner Caps cap
and Burner Heads (See Figure 3), BurnerHead. /---_- _
3, Discard all packing material located under all Burner Heads (if Figure4
applicable),
4, To replace Burner Heads & Caps, match the letters located
under center of Burner Caps with the letters located inside
Burner Head (See Figure 5), Place all Burner Heads & Caps
on the cooktop while carefully aligning the Electrodes into
slots or hobs of the Burner Heads (Figure 4), Note: The
Burner Heads should sit fiat on Cooktop Burner Skirts,
5, Unpack Burner Grates, NOTE: Do not force End Burner Figure5 Figure3
Grates down on cooktop, Be careful to fine up the 2 Grate
Pins located on each of the 2 End Burner Grates into the
Pilot hobs located on top of the Burner Caps (See Figure 5), Position Burner Grates on cooktop and check that all the
Burner Grate legs fie on the glass surface,
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE
GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners
are in use,
Loading ...
Loading ...
Loading ...