Loading ...
Loading ...
Loading ...
04
precautions and grasp the correct method of operation.
● Trained personnel: personnel who have undergone corresponding technical
training and have the necessary experience to be aware of the danger that may
be brought to him during the operation, and can take measures to reduce the
danger to himself or other personnel to at the lowest limit.
● The replacement of equipment or parts (including software) must be done
by professionals or authorized personnel.
2.1.3. Anti-static requirements
When installing the sub-panel with your main panel, you must wear anti-static
gloves or an anti-static wrist strap before touching the device. The other end of
the anti-static wrist strap should be properly grounded. Do not touch any bare
components directly with your hands.
2.1.4. Drilling
The following safety precautions are to be considered when drilling holes on the
wall or into the ground:
● It is strictly forbidden to drill holes into the equipment. Drilling will alter and
damage the electromagnetic shielding performance of the equipment, internal
components, and cables. The risk of metal shavings entering the device can
cause short circuits on the circuit board.
● Wear goggles and protective gloves when drilling holes.
● The equipment should be shielded and protected during the drilling process
to prevent debris from falling into the equipment. After drilling, any debris
which may have landed on the equipment should be removed and cleaned on
time.
2.2. Installation environment requirements
● When the equipment is running, please do not block the vents or the heat
dissipation system in order to prevent high temperatures and/or res.
● The equipment should be installed in an area away from liquids. It is
forbidden to install it near or below water pipes, air outlets and other locations
that are prone to water condensation.
● It is forbidden to install the unit underneath pipes, windows or other similar
areas that are prone to water leaks in order to prevent liquids from entering
into the equipment. Failure to do so may result in a short circuit.
Loading ...
Loading ...
Loading ...