Loading ...
Loading ...
Loading ...
12
INSTALLATION INSTRUCTIONS
Mounting dryer on wall
1
Determine the position of the
dryer on the wall and mark the
bracket position. A minimum
of 50mm is needed between
the top of the dryer and the
ceiling for ease of installation.
If mounting above a washing
machine, allow sufficient
room to open the lid of the
washer. Refer to page 11 for
lidclearances.
2
Fix the wall hanging brackets to
the wall securely, ie into the stud.
If the studs are too far apart, fit a
timber slat to the studs and then
mount the brackets to the slat. If
a slat is used install a second slat
behind the spacers to ensure the
dryer is horizontal. The distance
between the centre of each
bracket is 555mm (A).
3
To install the hooks onto the
dryer, remove one screw from
each side (B), reuse these
screwswith two more (each
side) from the kit to fasten the
hooks in place.
4
Remove plastic plugs from the
back of the dryer and screw the
spacers provided in place (C).
5
With assistance, mount the dryer
on the wall brackets.
6
Fit inverted control panel over
the existing panel.
7
Adjust the display to read
correctly on an inverted panel:
For DE7060M, DE6060M and
DE5060M press and hold the
‘Keylock’ and ‘Heavy’ buttons
for three seconds.
For DE4560M press and hold
the ‘Keylock’ and ‘Air Dry’
buttons for three seconds.
The dryer will beep to indicate
you have made a correct
selection, and the display will
change after three seconds.
Repeat the same steps to
return the panel to the factory
setting.
From centre
of top hole
From bottom
of dryer
C
B
A
835mm
555mm
555mm
Loading ...
Loading ...
Loading ...