Loading ...
Loading ...
Loading ...
5.1 SAFETY PRECAUTIONS
1. The vehicle to be lifted should never exceed the rated capacity of the jack.
2. The maximum stroke of the jack indicated on the label should never be exceeded.
3. The jack should be supported on a solid, level and horizontal surface which is well
illuminated and free of obstructions. Never stand the jack on a surface which may sink.
4. Ensure that there are no persons inside the vehicle to be lifted. Switch off the engine
and apply the brake. Ensure the vehicle or element to be lifted against any type of
sliding. Use chocks if appropriate (1). Do not enter the vehicle or start the engine whilst
it is supported on the jack or appropriate stands. The jack is a lifting device only and
should never be used to move the vehicle.
5. Position the jack under the manufacturer’s recommended lifting point for the vehicle
and ensure that it is not corroded, dirty or greasy. This point should remain centred
over the jack saddle. All off-centred loads can slip and accidents may result.
6. During raising and lowering of the load, all precautions should be taken to avoid
movement of the vehicle load. Traffic may cause the raised vehicle to rock during
roadside use of the jack.
7. The jack should be positioned so as to avoid the need for the user to introduce any part
of his/her body underneath the vehicle. Never work under a raised vehicle without
supporting it with axle stands (5) or other appropriate methods. Never position any part
of your body near the movable elements of the jack.
8. It is necessary for the operator to be able to observe the lifting device and the load
during all movements. In the presence of dangerous conditions, such as movement of
the vehicle, etc, the lifting process must be interrupted.
9. Ensure that there are no persons or obstructions underneath the vehicle prior to
lowering.
10. As an additional safety measure against overload, the jack is fitted with an overload
valve set at the factory and which should not be adjusted under any circumstances. If
the capacity of the jack is exceeded, the overload valve will stop the lifting operation.
CAUTION:
• Use only on a firm, level surface, concrete is preferred.
• Do not exceed the rated capacity of this jack.
• This is a lifting device only ... do not work under the vehicle without proper support
devices, such as axle stands.
• Make sure that the lifting point is stable and correctly centred on the jack saddle.
• Familiarize yourself thoroughly with this manual before operating to prevent damage to
the jack, property, or personal injury.
1 - BEFORE POSITIONING THE JACK, YOU SHOULD ENSURE
THE FOLLOWING:
i. Vehicle should be clear of all passengers.
Transmission should be in gear (or ‘Park’
for automatic transmissions) and the
handbrake applied.
ii. To prevent vehicle from movement,
wheels should be securely blocked
with wheel chocks
(Draper Stock No.54500).
2 - CORRECT POSITIONING:
The jack should be positioned under the approved lifting points for the vehicle.
Since these points may vary with each vehicle, it is important to refer to the vehicle
manufacturer’s or Haynes workshop manuals.
4 - NEVER EXCEED THE JACK’S RATED CAPACITY.
NEVER work under a vehicle without axle stands correctly
supporting the vehicle weight.
5 - WORKING UNDER THE VEHICLE:
It is extremely important, when working under the vehicle,
to ensure axle stands are always used.
✘
✘
✓
3 - TERRAIN:
The jack should be operated on a hard and level surface as
the location will permit, concrete is preferred.
5. HEALTH & SAFETY INFORMATION
5. HEALTH & SAFETY INFORMATION
7
6
Loading ...
Loading ...
Loading ...