Loading ...
Loading ...
Loading ...
Installation
About the Safety Supply Hose
The safety supply hose consists of double walls. The
hose's system guarantees its intervention by blocking
the flow of water in case of the supply hose breaking
and when the air space between the supply hose itself
and the outer corrugated hose is full of water.
WARNING! In order to avoid water staying in the inlet
hose, please close the hydrant after using.
WARNING! A hose that attaches to a sink spray
can burst if it is installed on the same water line
as the dishwasher. If your sink has one, it is
recommended that the hose be disconnected
and the hole plugged.
How to disconnect the safety supply hose
1. Turn off the water.
2. Release the water pressure by depressing the
pressure release button. This relieves water
pressure and protects you, and the room, from
severe splashing.
3. Unscrew the safety supply hose from the faucet.
Cold Water Connection
How to Connect the safety supply hose
The appliance must be connected to the water mains
using new hose-sets. The old hose-sets should not be
reused.
Water pressure must be between 0.04 MPa and
1 MPa. If the pressure is below the minimum, consult
our Service Department for advice.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure
that the water is clear. This precaution is needed to
avoid the risk of the water inlet getting blocked and
damaging the appliance.
1. Pull the safety supply hose completely out from the
storage compartment located at the rear of
dishwasher.
2. Connect the cold water supply hose to a threaded
3/4(inch) connector and make sure that it is
fastened tightly in place.
3. Turn water fully on before starting the dishwasher.
Page 12
Using Your Dishwasher
Damage to glassware and other dishes
Possible Causes
Type of glass or manufacturing process. Chemical
Ÿ
composition of detergent.
Water temperature and duration of dishwasher
Ÿ
program.
Suggested remedy:
Use glassware or porcelain dishes that have been
Ÿ
marked dishwasher-proof by the manufacturer
Use a mild detergent that is described as kind of
Ÿ
dishes If necessary, seek further information from
detergent manufacturers.
Select a program with as low a temperature.
Ÿ
To prevent damage, take glass and cutlery out of
Ÿ
the dishwasher as soon as possible after the
program has ended. as possible after the program
has ended.
Cutlery Basket
Cutlery should be placed in the cutlery rack
separately from each other in the appropriate
positions. Make sure the utensils do not nest
together, this may cause bad performance.
For a top quality clean, place the silverware in the
basket making sure that:
They do not nest together.
Ÿ
Silverware is placed with the male face up.
Ÿ
Long utensils in the middle.
Ÿ
Teaspoons4
Soup spoons
2
Forks
1
Knives
5
3
Dessert spoons
4
1
4
4
5
3
3
3
3
2
2
1
Page 21
Loading ...
Loading ...
Loading ...