Loading ...
Loading ...
Loading ...
WARNING: Operate this unit onIy in a
weII-ventiIated outdoor area.
Carbon monoxide exhaust fumes can be lethal in a
confined area.
WARNING; Avoid acddental starting,
Make sure you are in the
starting position when pulling the starter rope (Fig. 5).
To avoid serious injury, the operator and unit must be
in a stable position while starting.
STARTING iNSTRUCTiONS
1.
2_
,_ ,, ,,i@,_ 3.
NOTE:
Mix gas with oil. Fill fuel tank with fuel/oil mixture.
See Oil and Fuel Mixing Instructions.
Make sure the On/Off Stop Contro] is in the ON [m]
position (Fig. 3).
Fully press and release the primer bulb 10 times,
slowly. Some amount of fuel should be visible in the
primer bulb and fuel lines (Fig. 4). [f you can't see
fuel in the bulb, press and release the bulb as many
times as it takes before you can see fuel in it.
Push the red EZ-Fire TM Lever towards the primer
bulb until it clicks and locks into place (Fig. 4).
The unit uses the Jncredi-Pull TM starting system
with MAX FiRE iGNiTiON TM , which significandy
reduces the effort required to start the engine. You
must pull the starter rope out far enough to hear
the engine attempt to start. There is no need to
pull the rope briskly-- there is no harsh resistance
when pulling. Be aware that this starting method is
vastly different from (and much easier than) what
you may be used to.
with a controlled and steady motion up to 10
times, until the engine starts.
6. When the engine starts, squeeze the throttle control
for 15 to 30 seconds. This will warm up the unit. The
red EZ-Fire TM lever will click off automatically when
you squeeze the throttle control.
JFoooThe engine does not start, go back to step 3.
......................JFoooTheengine stops while you are squeezing the
throttle, go back to step 4.
JFoooThe engine stops before you squeeze the throttle
control, hold the throttle control and pull the starter
rope until the trimmer starts.
NOTE: If you are having trouble starting the unit or are
operating in extreme temperatures (below 40° F,
above 90° F), refer to the Troubleshooting section.
STOPPING iNSTRUCTiONS
1. Release your finger from the throttle control. Allow the engine
to cool down by idling.
2. Put the On/Off Stop Control in the OFF (O) position (Fig. 3).
Start/On,
F_g.3
Primer
Bulb
Fig. 4
\lnered,-Pu,!
_ Stop/Off (O)
Throttle
Control
Red EZ:Fire TM
Lever
Starting Position
Handle
Fig. 5
Loading ...
Loading ...
Loading ...