Loading ...
Loading ...
Loading ...
EN
Picture Mode
137
SETTINGS ON THE FLASH UNIT
Operating mode
TTL
Automatic camera control
A
Aperture priority
M
The flash exposure must be set to an output level to
match the aperture and shutter speed settings
determined by the camera.
Set the flash unit to TTL mode to allow automatic control of the
unit by the camera.
When set to A, subjects with above or below average brightness
may not be exposed correctly.
In M mode, the flash exposure must be set to an output level to
match the aperture and shutter speed settings determined by the
camera by setting an appropriate partial light power level.
Note
• Please read the relevant manual provided with third party flash
units regarding their various operating modes.
FLASH CONTROL
The settings and functions described in the following sections only
apply to settings and functions available in this camera and in
system-compatible flash units.
SYNC POINT
Flash exposures are lit by two light sources:
– ambient light
– Flash
Any subject elements lit primarily by the flash will almost always be
rendered in perfect focus by the short burst of light, provided the
focus is set correctly. All other subject elements in the same frame
lit by ambient light or lit from within will be rendered with varying
degrees of sharpness. Whether or not these object elements will
be rendered in sharp focus or blurred, as well as the degree of
"blurriness" depends on two interdependent factors:
– the shutter speeds
– the speed of movement of the subject elements or camera
during recording
The longer the shutter speed and the faster the motion, the greater
the difference between the two superimposed partial images.
Loading ...
Loading ...
Loading ...