Loading ...
Loading ...
Loading ...
Dispensers
Bleach Dispenser
Bleach dispenser is located in left
front corner under loading door.
Bleach
dispenser
I
Use only liquid bleach in
dispenser. To use powdered
bleach, add to wash tub with
detergent.
Carefully pour recommended amount
of bleach into dispenser during first
washer fill. See table.
Be careful not to spill undiluted
bleach. It is a strong chemical and
can damage cabinet finishes and
some fabrics if not properly diluted.
Follow bleach manufacturer's label for
proper use.
LOAD SIZE BLEACH
(Max Amt.)
SUPER PLUS 1 cup
LARGE 1 cup
MEDIUM 3/4 cup
SMALL 1/2 cup
Fabric Softener
Dispenser
Fabric softener dispenser is
located on top of agitator.
Dispenser automatically releases
liquid fabric softener at proper time
during rinse cycle.
To use dispenser, follow these steps:
1. Pour liquid fabric softener into dispenser, using amount recommended
on package.
Fabric
so_ener
dispenser
2,
Fabric Softener Use Tips
• Liquid fabric softeners are
dispensed during final rinse. Do
not combine with bleach, bluing,
starch, detergents, soaps, or
packaged water conditioners
during rinse.
• Do not use fabric softener in
dispenser during DOUBLE WASH
cycle.
• Do not mix powdered detergent
with liquid softener in dispenser or
softener will become gummy.
,
Add water up to fill level, but do not exceed tip of fill arrow indicator.
FABRIC SOFTENER MUST BE DILUTED FOR USE.
• Do not stop washer during first spin or dispenser will empty too
soon.
• Never pour fabric softener directly onto clothes or spots and stains
may result. To remove softener stains, soak in soapy solution of
Sard TM Wonder Soap or IvoryTM soap, or rub stain with bar of Sard TM or
Ivory TM soap and wash garment as usual.
• For best softener performance, set water level to medium or higher.
Clean softener dispenser after
each use. Remove dispenser
housing from agitator by
squeezing lower part ofdispenser
and pulling up on housing while
tilting slightly to expose
dispenser cup. Rinse dispenser
housing and cup in hot soapy
water.
Clean funnel shape in top of
agitator and inside of agitator. Use small brush on hole and slots in two
funnel rings for thorough cleaning.
After cleaning, re-install dispenser cup. Push dispenser housing
directly down onto top of agitator until firmly snapped together.
To prevent build-up, fill dispenser with clean water inwash cycles when
not using softener.
7
Loading ...
Loading ...
Loading ...