Loading ...
Loading ...
Loading ...
Trouble Shooting (cont'd)
TOPIC
WATER
POSSIBLE CAUSE SOLUTION
Wash load too wet after spin Overloaded wash tub Do not overload washer.
Unbalanced load Rearrange load to allow proper spin.
Kinked drain hose Straighten drain hose.
Water enters slowly or does Inadequate main water supply Check water pressure at another faucet in house. Wait for
not enter washer water supply and pressure to increase.
Water supply faucets partly closed Fully open hot and cold water supply faucets.
Water being used elsewhere in house Water pressure must be at least 20 psi (138 kPa). Avoid
running water elsewhere when washer is filling.
Clogged water inlet filters Disconnect water fill hoses from faucet. Clean and
reposition screen filters. Reconnect water fill hoses,
Kinked water inlet hoses Straighten hoses.
Water level does not cover Incorrect water leveFIoad size selection Select higher water level/load size. Add water by turning
clothes selector to RESET and back to larger load size.
Overloaded wash tub Do not overload washer. Largest dry load level should not
be higher than bottom of fabric softener dispenser or top of
agitator.
Warm or hot water not hot Water heater temperature set too low; water Use candy/meat thermometer to measure hot water
enough heater too far from washer temperature at nearby faucet. Water temperature should
be at least 140°F (60°C) Adjust water heater as
necessary.
Hot water being used elsewhere in house Avoid using hot water elsewhere before or during washer
use, or there may not be enough hot water for proper
cleaning. If problem continues, enlarge capacity of hot
water system, or use for only one application at a time.
Water drains slowly or does Drain hose kinked or clogged Clean and straighten drain hose.
not drain
Water leaks Loose fill hose connections Check and tighten all hose/faucet connections. Install
rubber sealing washers provided.
Clogged drain pipes Unclog drain pipes. Call plumber if necessary.
Changed water levels dudng fill Always use RESET on water level switch when changing
water level. Do not hold switch at RESET; return switch to
desired load size,
Oversudsing Use less detergent.
Incorrect wash and rinse Hot and cold water hoses connected to Check hose connections. Connect hot water hose to hot
temperatures wrong supply faucets water faucet; connect cold water hose to cold water faucet.
Water enters washer, but tub Incorrect standpipe height for drain hose Recommended standpipe height is 36" (91.44 cm); for low
does not fill standpipes, install Siphon Break Kit (part #562P3). See
/nsta//ation Instructions for details.
11
Loading ...