Loading ...
Loading ...
Loading ...
W415-1463 / C / 10.19.17
18
EN
5.0 finishing
To avoid being damaged during shipping, the appliance has
been bolted to the pallet and must be unbolted before the
appliance can be installed.
NOTE: If installing the optional ash drawer, see
“OPTIONAL ASH DRAWER KIT (EP20LAD)” section
prior heat shield and leg installation.
NOTE: Legs may need to be adjusted in order to
properly align with the heat shield holes.
A. With the bolt through the legs, feed the washer and lock
washer onto the bolt. Thread the nut a thread or two
onto the bolt and slide the leg onto the slot on appliance
as illustrated. NOTE: Bolts must be tight prior to heat
shield installation.
B. Slide the heat shield over the four bolts. Finally, secure
the heat shield in place using the remaining nuts.
C. Lift the appliance up and gently set down on all four legs.
Do not pivot appliance up on its legs, as this could result
in damage to the legs.
For additional logo placement locations, see “OPTIONAL ASH DRAWER”
section.
!
WARNING
KNOCKOUT NOT TO BE REMOVED EXCEPT WHEN INSTALLING THE OPTIONAL ASH DRAWER KIT.
LOGO
PLACEMENT
KNOCKOUT
(SEE WARNING
ABOVE)
5.1 leg installation
Loading ...
Loading ...
Loading ...