Loading ...
Loading ...
Loading ...
• Grass catcher components are subject to wear,
damage, and deterioration, which could expose
moving parts or allow objects to be thrown.
Frequently check components and replace with
manufacturer's recommended parts+ when
necessary.
• Check brake operation frequently. Adjust and
service as required.
• Use only factory authorized replacement parts
when making repairs.
• Always comply with factory specifications on all
settings and adjustments.
Only authorized service locations should be
utilized for major service and repair requirements.
• Never attempt to make major repairs on this unit
unless you have been properly trained. Improper
service procedures can result in hazardous
operation, equipment damage and voiding of
manufacturer's warranty.
:i WARNING
Never operate on slopes greater than 20+
(36.4 percent) which is a rise of 7-1f4 feet (220 era)
vertically in 20 feet (607 era) horizontally.
Select sl_,+_ground speed befl_re driving onto slope
In addition to front and I'ear weights, use extra caution
when operating on slopes with rear-mounted grass
catcher
Mow ACROSS the sJope never up and down the
race. _+secaution when changing directions and DO
NOT START OR STOP ON SLOPE.
i ! i i:
Note: Please refer to Parts List for correct part identification and placement. Parts list reference
numbers are called out by sheet number followed by reference number(s) on that sheet: (1:1) indicates
Sheet 1, reference number 1; (2:32,34-38) indicates Sheet 2, reference numbers 32 through 38 excluding
33; etc.
Note: Some assembly steps may already have been completed at the factory. Simply disregard factory-
completed steps and proceed to the next assembly step.
CASTER ASSEMBLY
• Remove Lynch pin (1:16) and all but the bottom
1/4" spacer (1:15) from Caster horn (1:13).
• Slide Caster horn up through Caster arm (1:8),
securing with same spacers and lynch pin
removed in previous step. NOTE: When
assembled in this manner, cutting height will be
approximately 2-1/2".
• With front of mower propped up, install caster
assemblies to front of Blade Deck (1:1) with
twelve 3/8" x 1" bolts, flat washers, and
serrated flange nuts (1:9-11). (Bolts are
installed from inside of mower deck.) Tighten
all bolts securely. Lower front of mower.
GVTP SM32-R0303.1
Loading ...
Loading ...
Loading ...