Loading ...
Loading ...
Loading ...
page 5
5. Fan Assembly (with downrod). (cont.)
hanging ball slot
hanging bracket tab
With the hanging bracket secured to the
outlet box and able to support the fan, you are
now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod through
opening in hanging bracket and let hanging
ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the
hanging bracket tab.
WARNING: Failure to align slot in hanging ball
with tab in hanging bracket may result in
serious injury or death.
Tip: Seek the help of another person to hold
the stepladder in place and to help lift the fan
up to you once you are set on the ladder.
Continue to "Wiring" section on page 6 for
wiring diagram.
6. Fan Assembly (flushmount).
Remove and set aside canopy cover to
reveal 6 holes. [Refer to diagram 1.] Notice
that 3 of these holes are larger.
Locate 6 screws in top of motor housing
yoke. Observe that 3 of the screw heads
are almost flush with the yoke plate
surface and remove these 3 screws/lock
washers. [Leave the other 3 screws intact.]
Thread wiring through canopy. Place
canopy over yoke, aligning larger holes in
canopy with the 3 existing screws in top of
motor housing. Re-insert the 3 screws/lock
washers that were previously removed
into the remaining holes. Securely tighten
these screws. [Refer to diagram 2.]
To prepare the fan for wiring, hang fan
onto hanging bracket by sliding the
canopy over the hanging bracket tab. (Use
one of the non-slotted holes on the rim of
the canopy to do so.) [Refer to diagram 3.]
canopy
canopy cover
canopy
motor
housing
yoke
yoke
flush
screw
raised
screw
flush screw/
lock washer
diagram 1
motor
housing
diagram 2
canopy
motor housing
diagram 3
hanging
bracket tab
Loading ...
Loading ...
Loading ...