Loading ...
Loading ...
Loading ...
Reversible Door
Instructions (continued)
=Feezer Door LockH_ndleor=
DovetalJ Button
7. (When needed,, please refer to your
literature pack,) Reverse handles while doors
are off, Remove the two screws attaching the
handle to the bottom of the freezer door, Swing
bottom of handle away from the door and slide
handleup and off dovetail button° Removescrew
and dovetail button and install on other side,
moving hole plug from corresponding hole to the
opposite side, Reverse instructions for
reattaching handle. Startwith handle offset away
from the door. Placetop of handle over dovetail
button, swing handle into an upright position
and push upward, locking it into place, Secure
bottom of handle with screws,
Hinge Pin
LowLrHinge
or
Hlnge
Pin
Washer
Bolts Lower Hinge
Refrigerator Door
$¢rews
Lock Handle Ov_t
OoveL_11Bu_on
Trim Lock A_/h_Ev_
Trim Lec_
8. (When needed, please refer
to your literature pack.) To
remove handle: PuUdown to
slide trim off bottom of handle
Remove the two screws
attaching the handle to the top
of the refrigerator door. Swing
the top of handle away from the
door and slide handle down and
off dovetail button Remove
screw and dovetail button and
installonother side, movinghole
plugs from corresponding holes
to the opposite side. Reverse
instructions for reattaching
handle, Start with the handle
offset away from the door, Place
bottom of handle over dovetail
button, swing handle into an
upright position and push
downward, locking it into place,
Secure top of handle with
screws, Replace trim
Trim Removal (Full-Length Trim models only):
In some models, the refrigerator door has a full length trim piece which
continuesfrom the bottom of the handle to the bottom of the door The top of
the trim fits around the baseof the handle An adhesive "trim lock" ispositioned
about half-way down. The bottom of the trim is held in place by either an
adhesivetrim took, or a trim lock with two prongs inserted into a hole on the
face of the door. Removethe trim by gently pulling the trim lock areasout and
away from the door. When the trim isfree from the door, gently pull the trim
down and away from the base of the handle, using a slight side to side motion
To reattach trim: Slideboth trim locksout of trim. Insert the new adhesivetrim
lockscontained in your literature pack, NOTE: Trim lock must be removed and
installed by sliding OVERthe two donut shaped areas, install trim to handle by
sliding over base of handle Carefully align trim and press down at trim lock
]ocations.Replacehole plug on opposite side Use rubbing alcohol to remove
any adhesive residue from old trim lock location(s).
Piug
Center Hinge
(ups{de down)
9. Using a putty knife, remove black plastic plug
(not shown) from front of baseand reinstallin the
oppositeset of lower hinge holes.Assemblelower
hinge to cabinet Install hinge pin in opposite
hinge hole from which it was removed install the
washer (some models) on the lower hinge pin and
insert hinge bolts, but do not tighten Hinges will
haveto remain loose against cabinet to align door.
10, Turn center hinge upside down and secureto
cabinet as shown, using the screws which are in
the new holes, lnstaiI refrigerator door on lower
hinge pin, Align door with edge of cabinet Hold
the door on front of cabinet
Loading ...
Loading ...
Loading ...