Loading ...
Loading ...
3" AIR SPACE
CJearance
Proper air circulation and leveling willensure efficient operation,
P_ISE
LOWER
Screw-type Levelers (some models)
LOWER
CABINET
CABINET
Exposed bolt (some models)
LOWER
CABINET
CABINET
Sunkenbolt (somemodels)
Before starting the refrigerator, follow these important first steps:
Location
• Choose a place that is near a grounded electrical outlet DO NOT use an
extension cord or an adapter plug
• If possible, place the refrigerator out of direct sunlight and away from the
range, dishwasher or other heat sources,.
. The refrigerator must be installed on a floor that is level and strong enough
to suppor_ a fully loaded refrigerator°
• Consider water supply availability for models equipped with an automatic ice
maker,.
Installation
o Do not install the refrigerator where the temperature will drop below 60°F
(I 5°C) or rise above 110°F (43°C) The compressor will not be able to maintain
proper temperatures.
* A!low space around the unit for good air circulation. Leave a I inch (25 mm)
space behind and a 3 inch (75 ram) space above the refrigerator for adequate
circulation
, In a recessed installation, allow an extra 112inch (10-I 5 ram) on each side
for ease of installation: .........................
, For best circulation, elevate the unit 1 inch (25 mm) from the floor, especially
if the floor is carpeted
Door Opening
The doors should open to allow easy access to a counter when removing food,
,__Do not position the refrigerator so you have to walk aroundthe refrigerator
doors.
, Reversethe doors if necessary. See "Reversible Door instructions.. _
Leveling
All four corners of refrigerator must rest firmly on a solid floor. Some models are
e_u!pped withadjustab_le screw:type !ev_e!ers.Others are equjp_p_edwit_h_ro!lers.- tf
your refrigerator did not come with rollers, theycan be purchased from your dealer,
, To adjust screw-type levelers {some models): Tip cabinet back slightly and
raise adjusting bolts as needed.
= To adjust front rollers {some models); Use a screwdriver, 3/8" socket
wrench, or nutdriver to adjust rollers as shown.
RAISE THE FRONT of cabinet enough so doors will close freely when opened
halfway. Level cabinet side to side,
Cleaning
• Wash the inside, all removable parts and the outside with mild detergent and
warm water. Wipe dry DO NOT USE HARSH CLEANERS ON THESE
SURFACES.
• Do not use razor blades or other sharp instruments which can scratch the
appliance surface, when removing adhesive labels. Any glue left from the
tape or energy label can be removed with a mixture of warm water and mild
detergent, or touch the residue with the sticky side of tape already removed.
, DO NOT REMOVETHE SERIALPLATE
Loading ...
Loading ...
Loading ...