Loading ...
Loading ...
Loading ...
33
23MMP35209REV1.0
Installing the tip restraint hardware
• When the Tipping Restraint
Hardware (OO) is properly installed,
it can provide protection against
unexpected tipping of the Unit
due to small tremors, bumps or
climbing.
• Each Tipping Restraint Hardware
(OO) includes one Unit Anchor,
one Wall Anchor, one Anchor Tether,
and four Anchor Screws. Use these
to complete the following steps for
a proper installation.
• Locate a secure wall stud behind
the unit closest to left side.
• Align the Unit Anchor with a
wall stud and attach to the Unit
with two Anchor Screws using a
Philips screwdriver. The Anchor
Screws must pass through the Top
Assembly for proper installation.
• Align the Wall Anchor in the center of the wall stud, at level with the Unit
Anchor, and with two Anchor Screws using a Philips screwdriver.
• On the Anchor Tether, detach the cable from the connector and
loop the loose cable through the eyelets on the Wall Anchor and Unit
Anchor. Reattach the loose cable to the connector, but do not tighten.
• Locate a secure wall stud behind the Unit closest to the right side and
repeat the steps above.
• Tighten both Anchor Tethers by pulling the cable the through
connector.
NOTE: Installation of the Tipping Restraint Hardware (OO) will provide a
small space between the wall and the Unit. This will allow you to run
power cords and connector cables to your television or other devices
placed on top of the Unit.
26
Wall Stud
Poteau Mural
Montante De
Madera
OO
[x1]
Loading ...
Loading ...
Loading ...