Loading ...
Loading ...
Loading ...
STEP 2
Connecting the water and the drain
Connecting the water supply hose
_The water supply hoses are not supplied with your washer
....... and must be purchased separately. Before installing the water
supply hoses, make sure there are rubber gaskets inside the
fittings at both ends of each new water hose. Installing the
water supply hoses without rubber gaskets can cause water
leakage.
_When you initially install the washer, be sure to use new hoses.
....... Failing to do so may result in a water leakage or overflow and
may damage your property.
ADo not connect multiple water supply hoses together to
....... increase the length of the supply hose. Hoses connected this
way can leak and the leakage can cause electrical shock. If a
hose is too short, replace the hose with a longer, high pressure hose.
1. Connect the ends of the water supply hoses to the HOT and COLD faucets.
2. Tighten the fittings by hand until they are snug, and then tighten them an
additional two-thirds of a turn with a wrench.
Z_ When you fasten the fittings, do not fasten them too tightly or apply
....... tape or sealant to the faucets or water supply intakes. This can
damage the fittings.
After you have connected the water supply hoses to the faucets,
ensure that they are connected correctly by pulling the water supply hoses
downwards
3. Place the unconnected ends of the hoses into a bucket and open
the faucets connected to the two water supply hoses for 10 or 15
seconds to remove any foreign substances from the hoses. Close the
faucets before continuing.
Cold
Washer
Hot
4. Connect the ends of the water supply hoses to the water supply
intake connections at the back of the washer.
Z_ The water supply hose connected to the HOT faucet must be
....... connected to the hot water supply intake and the water hose
connected to the COLD faucet must be connected to the COLD
water supply intake.
5. Tighten the fittings by hand until they are snug, and then tighten them
an additional two-thirds of a turn with a wrench.
To ensure the correct water usage, connect both the HOT and
COLD water faucets. If either or both are not connected, an
"nF" (no fill) error can occur.
If you do not want to use the HOT water supply hose, insert
the water intake cap into the HOT water supply intake hole. In
this case, you must select the Tap Cold option for the water
temperature.If you select the Tap Cold option, all the lamps for
the water temperature options are turned off.
//_ Confirm that the water supply hoses are not twisted or bent. If
....... the hoses are twisted or bent, the hoses can leak and cause
electric shock due to the water leakage.
6. Turn on the HOT and COLD water supplies and check all the water
supply intake connections and the faucets for water leaks.
/
instaling your washer 15
Loading ...
Loading ...
Loading ...