Loading ...
Loading ...
Loading ...
4, 4
identify the Ramp Axle (128), which is the longest axle,
Slide a Ramp Axle Cover (132) onto an M6 x 18mm
Patch Screw (67) as shown, Tighten the Patch Screw
into one end of the Ramp Axle, Apply a small amount of
the included grease to the Ramp Axle,
Have a second person hold the two Ramp Spacers
(130) against the sides of the Frame (1) so they cover
the indicated tubes on the Frame, Lift the Flex Bars (not
shown) out of the way and align the round tubes on the
Ramp (133) with the Ramp Spacers, Make sure that
the Ramp is turned as shown, insert the Ramp Axle
(128) into the Ramp, the Ramp Spacers, and the
Frame, Note: it may be helpful to use a rubber mallet,
Slide the other Ramp Cover (132) onto an M6 x 18mm
Patch Screw (67) as shown, Tighten the Patch Screw
into the other end of the Ramp Axle (128),
identify the Incline Axle (137), which is the longest
remaining axle, Slide an M6 Washer (58) onto an M6 x
18mm Patch Screw (67), Tighten the Patch Screw into
one end of the Incline Axle, Apply a small amount of
grease to the Incline Axle,
Raise the Ramp (133), insert the Incline Axle (137) into
one side of the Ramp, through an Incline Spacer (123),
through the motor screw, through the other Incline
Spacer, and then into the other side of the Ramp, As
you insert the lncJine Axle through the motor screw,
make sure that the motor screw does not turn.
Slide an M6 Washer (58) onto an M6 x 18mm Patch
Screw (67), Tighten the Patch Screw into the other end
of the Incline Axle (137),
Have another person hold the Upright (2) near the
Frame (1), Connect the Upper Wire Harness (86) to the
Lower Wire Harness (87), Next, slide the Upright onto
the Frame, Be carefuJ to avoid disconnecting or
pinching the Wire Harnesses. Attach the Upright with
two M8 x 54mm Button Screws (33), two M8 x 38mm
Button Screws (70), and four M8 Split Washers (94), Be
careful to avoid damaging the Wire Harnesses with
the Button Screws.
Attach the Water Bottle Holder (91) to the Upright (2)
with two M4 x 16mm Screws (66),
Hold the Left and Right Handlebar Covers (26, 29)
around the Upright (2) and the indicated tube, Press the
Handlebar Covers together and connect them with an
M4 x 16mm Round Head Screw (45),
Hold the Left and Right Upright Covers (34, 38) around
the Upright (2), Attach the Upright Covers with two M4 x
14mm Round Head Screws (93),
7
133
G rease
132
128
_130
130 Tube .
133
Motor
Grease
137
38
2
93
Make sure
the wire
harnesses
do not get
pinched and
damaged
during this
step.
Tube
_91
Loading ...
Loading ...
Loading ...