Loading ...
Loading ...
Loading ...
10 INSTALLATION INSTRUCTIONS
Installation in a double-hung sash
window
1.Cut the adhesive foam seals (A) to the
proper lengths and attach them to the
window and sill.(Fig.6)
2.Open the window sash and place the
window slider kit on the window sill (Fig.7).
Attach the window slider kit to the window
sill. Adjust the length of the window slider
kit according to the width of window. Screw
down the two screws on the window slider
kit. See Fig.7.
Cut the adjustable window slider kit if the
width of window is less than 26.6
inches(Fig.8).
Fig.6
Foam seal A
(adhesive type)
Fig.7
screws
Window slider kit
window sill
26.6"~52.5"
3. Ax the connector A into the window
slider kit and seal.(Fig.3&4)
The hose can be extended from its original
length of 15" up to 59", but try to maintain
the minimum required length. Also make
sure that the hose does not have any sharp
bends or sags.(Fig.5)
Vertical
window
Window Slider Kit
Minimum:26.6(67.5cm)
Maxmum:52.5(133cm)
Fig.3
Horizontal
window
Window Slider Kit
Minimum:26.6(67.5cm)
Maxmum:52.5(133cm)
Fig.4
Fig.5
2. Install the connector B into the unit
(Fig.2).
Fig.1A
Extend the side of hose
Slide onto
1
Lock
2
Fig.2
1. Extend either side of the hose(Fig.1).
Loading ...
Loading ...
Loading ...