Loading ...
Loading ...
Loading ...
16
EN
www.napoleon.com N415-0573 MAR 30.20
Low heat / Low ame
when valve turned to
high.
For propane - improper lighng
procedure.
For natural gas - undersized supply
line.
For both gases - improper
preheang.
Ensure lighng procedure is followed
carefully. All gas grill valves must
be in the o posion when the tank
valve is turned on. Turn tank on slowly
to allow pressure to equalize. See
lighng instrucons.
Pipe must be sized according to
installaon code.
Preheat grill with both main burners
on high for 10 to 15 minutes.
Excessive are-ups/
uneven heat.
Sear plates installed incorrectly.
Improper preheang.
Excessive grease and ash build on
sear plates and in drip pan.
Ensure sear plates are installed with
the holes towards the front and the
slots on the boom. See assembly
instrucons.
Preheat grill with both main burners
on high for 10 to 15 minutes.
Clean sear plates and drip pan
regularly. Do not line pan with
aluminum foil. Refer to cleaning
instrucons.
Burners burn with yellow
ame, accompanied by
the smell of gas.
Possible spider web or other
debris, or improper air shuer
adjustment.
Thoroughly clean burner by removing.
See general maintenance instrucons.
Open air shuer slightly according
to combuson air adjustment
instrucons. (This must be done by a
qualied gas installer.)
Flames li away from
burner, accompanied
by the smell of gas, and
possibly dicules in
lighng.
Improper air shuer adjustment. Close air shuer slightly according
to combuson air adjustment
instrucons. (This must be done by a
qualied gas installer.)
Rear and Side burners
will not light with the
igniter, but will light with
a match.
Dead baery / or installed
incorrectly.
Loose electrode wire or switch
terminal wires.
Liing ames on burner.
Replace with premium heavy duty
baery.
Check that electrode wire is rmly
pushed onto the terminal on the back
of the igniter. Check that the lead
wires from the module to the ignion
switch (if equipped) are rmly pushed
onto their respecve terminals.
Close air shuer slightly - see previous
problem.
Main burner will not light
with the igniter, but will
light with a match.
Jet-re outlet is dirty or clogged. Clean jet-re outlet with a so bristle
brush.
Loading ...
Loading ...
Loading ...