Loading ...
Loading ...
Loading ...
WARNING
Disconnect the machine from power source whenever
adjusting or replacing any parts.
CHANGING THE FILTERS
Refer to Figure 13
The inner and outer filters should be replaced and / or
cleaned depending on the amount of usage and the
environment of your workshop. Clogged filters will reduce
the amount of air circulation.
• Lift up on the clips located at the top and bottom of the
cabinet and remove the outer filter.
• Pull the inner filter from the cabinet. The inner filter can
be shaken out or washed to extend its life. The filter
should be completely dry before reinstalling into the unit.
NOTE: Do not use compressed air to blow out the
inner filter. The high pressure will damage the filter and
reduce filtering quality.
• Insert the new or cleaned inner filter and then install
the new outer filter. The arrow on the outer filter
indicates the air flow direction, ensure the filter is
positioned properly.
Figure 13
Clip
Inner
Outer
Arrow
REMOTE CONTROL BATTERY
REPLACEMENT
• Remove the battery compartment cover on the
remote control.
• Replace the batteries. Ensure the batteries are
oriented as shown inside the battery compartment. Use
AA batteries.
• Replace the battery compartment cover.
NOTE: When disposing batteries, think of the protection of
the environment. Check with your local authorities for an
environmentally safe way of battery disposal.
CHECKING AND REPLACING THE FUSE
Refer to Figure 14
If the unit overloads, the line inside the fuse will break to
cut the circuit and protect the unit.
To Replace the Fuse
1. Turn the fuse cap counterclockwise and pull the fuse out of
the control panel.
2. If damaged, replace the fuse (Part No. 1045-009, 4 Amps).
Place the new fuse into the fuse cap and insert it into
position. Tighten the fuse cap.
Figure 14
Fuse
Fuse Cap
MAINTENANCE
7
MAINTENANCE
7
Loading ...
Loading ...
Loading ...