Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
REPAIR PARTS
LiftMaster warrants to the first consumer purchaser of this product that it is free from defect in materials and/or workmanship
for a period of 1 year from the date of purchase.
NOTICE: This device complies with Part 15 of the FCC rules and
Industry Canada’s license-exempt RSSs. Operation is subject to the
following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any changes or modifi cations not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This device has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules and Industry
Canada ICES standard. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
LiftMaster.com • 1-800-528-2806
SYMPTOM CAUSE SOLUTION
The keypad will not program to
the operator.
The keypad is programmed to the
wrong frequency and encryption.
Program the keypad to match the operator's
frequency and encryption (see page 3).
The backlight and tone on the
keypad no longer work.
Battery may be dead. Replace battery with 9V Lithium battery.
Key press turns on backlight
but no beep.
Stuck button. Check that all buttons are not stuck.
PIN won’t learn. PIN already learned. Learn a new PIN. Exit Learn.
PIN won’t learn. Memory full. Erase a PIN to add a new pin. Perform Factory
Reset to erase all PINs.
PART NUMBER DESCRIPTION
K093A0763 Mounting Plate
K107A0031 Keys
ONE YEAR LIMITED WARRANTY
BATTERY
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 9V Lithium battery.
• DO NOT recharge, disassemble, heat above 212° F
(100° C) or incinerate.
Battery
Mounting plate
Faceplate
Battery Cover
The 9V Lithium battery should produce power for up to 5 years.
To replace the battery:
1. Unlock and remove the faceplate from the mounting plate.
2.
Remove the battery cover using a Phillips screw driver.
3. Remove the old battery and install new 9V Lithium battery.
Re-install inner cover.
4. Reattach the faceplate to the mounting plate and lock with
the key.
5. Dispose of old battery properly.
Loading ...
Loading ...
Loading ...