Loading ...
Loading ...
Loading ...
How To Install The Speed Control Rod
1. Put the speed select lever intothe
sixth gear position.
2. Attach the speed control rod (end
with 90 °bend) to the speed select
bracket with washer and cotter
pin. See Figure f0.
3. Put the speed select lever into the
first gear position.
4. Attach the ball joint, located on the
bottom end of the speed control
rod, to the shift yoke assembly.
See Figure 11. The fasteners are
attached to the ball joint at the
factory.
5. The length ot the ball joint and
speed control rod have been pre-
adjusted at the factory. If an adjust-
ment is required, loosen the nut.
Remove the fasteners to discon-
nect the ball joint from the shift
yoke assembly. To lengthen or
shorten the speed control rod, turn
the adapter to obtain the correct
length.
6. Make sure the speed select lever
functions correctly. Move the speed
select lever through all speeds.
Bracket
Speed
Control
Rod
Adapter
Joint
Speed Select
Lever
Cotter Pin
Figure 10
Shift Yoke
Assembly
Fasteners
Figure 11
How To Set The Skid Height
The snow thrower is equipped with
height adjustable skids mounted on
the outside of the auger housing. See
Figure 12. To adjust the height of the
skids, see To Adjust Skid Height para-
graph in the Service And Adjustment
section
Adjustable Skids
Figure 12
F-O31027L 10
Loading ...
Loading ...
Loading ...