Loading ...
Loading ...
Loading ...
Transport
8 Transport
25
DANGER!
If the machine is to be transported on a lorry or trailer, loading ramps with a suitable load-bearing capacity,
width and length must be used. The machine must only be loaded with the engine switched off, without a
driver, by being pushed on to the means of transport by an appropriate number of people. During trans-
port, close the petrol cock (if present), lower the cutting disc, apply the parking brake and appropriately
secure the machine on the means of transport with ropes or chains.
9 Potential faults and how to rectify them
IMPORTANT:
If a fault which is not listed in this table occurs, contact the specialist dealer. Once you have tried all of
the corrective measures described here with no success, contact the specialist dealer.
IMPORTANT:
Only use genuine spare parts from the manufacturer, which you can obtain from your specialist dealer.
This ensures that the implement will work reliably.
Fault Cause Corrective measure
V-belt running not OK V-belt pulley installed
incorrectly
Check the centring of the V-belt pul-
ley; the contact surfaces must be clean
and free of burr
Grinding sounds V-belt does not run over the V-belt
tensioner
Position the V-belt and V-belt ten-
sioner according to the installation
instructions
Premature V-belt wear The V-belt edges
and the V-belt idler pulley are
touching
Reposition the V-belt tensioner ac-
cording to the instructions
Loading ...
Loading ...
Loading ...