Loading ...
Loading ...
Loading ...
12
FINAL INSTALLATION
1.
1
K
B
J
Locate two canopy mounting screws (K) on underside
of mounting bracket (C) and remove canopy mounting
screw (K) closest to the open end of the mounting
bracket (C). Partially loosen the other canopy
mounting screw (K). Lift canopy (B) to mounting
bracket (C). Place rounded part of slotted hole in
canopy (B) over loosened canopy mounting screw (K)
and push up. Twist canopy (B) to lock. Re-insert
canopy mounting screw (K) that was removed, then
tighten both canopy mounting screws (K).
Use arrows on inside of canopy cover (J) to locate
knobs on center ring of canopy cover (J). Slide
canopy cover (J) up to canopy (B), aligning knobs on
canopy cover (J) with openings in bottom of canopy
(B). Press up firmly on the canopy cover (J) until it fits
into the bottom of the canopy (B) and then turn canopy
cover (J) about ½ in.
DANGER: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades (G). If screws are overtightened, blades (G)
may crack and break.
Partially insert three blade screws (CC) along with
three blade washers (BB) into holes in blade (G) to
attach blade arm (N) to blade (G). Then, tighten
each blade screw (CC) starting with the one in the
middle.
Repeat Step 2 for remaining blades (G) and blade
arms (N).
2.
Fiber Blade Washer x 18
BB
Hardware Used
D
2
BB
CC
G
N
3
G
N
CC
Blade Screw x 18
Knobs
Attach blade arms (N) to the bottom of motor housing
(D) with motor screws/lock washers (Q) previously
removed (Step 5, page 8). Tighten motor screws/lock
washers (Q) securely.
NOTE: Make sure to completely secure each blade
arm (N) before proceeding to the next.
3.
Q
Loading ...
Loading ...
Loading ...