Loading ...
Loading ...
Loading ...
POSiTIONiNG TABLE AND WORKPIECE
Lock the table to the column in a position so that the
tip of the drill isjust a littleabove the top of the work-
piece.
Always place a piece of BACK-UP MATERIAL (wood.
plywood..) on the table underneath the workpiece.
This will prevent "splintering" or making a heavy burr
on the underside of the workpiece as the drillbreaks
through. To keep the backup material from spinning
outof control, it must contact the left side of the column,
as illustrated.
WARNING: TO PREVENT THE WORKPIECE OR THE
BACKUP MATERIAL FROM BEING TORN FROM
YOUR HAND WHILE DRILLING, POSITION THEI_/I
AGAINST THE LEFT SIDE OF THE COLUMN. iF THE
WORKPICE OR THE BACKUP MATERIAL ARE NOT
LONG ENOUGH TO REACH THE COLUMN, CLAMP
THEM TO THE TABLE. FAILURE TO DO THiS
COULD RESULT iN PERSONAL INJURY.
WORKPIECE
MATERIAL
For small pieces that cannot be clamped to the table,
use a drill press vise (Optional accessory.)
WARNING: THE VISE MUST BE CLAMPED OR
BOLTED TO THE TABLE TO AVOID iNJURY FROM
SPINNING WORK AND ViSE OR TOOL BREAKAGE.
WORKPIECE
DRILL PRESS
VISE
BOLT OR CLAMP
VICE SECURELY
24
Loading ...
Loading ...
Loading ...