Loading ...
Loading ...
September 2016
TO USE
To Change the Display to °F:
1. Switch the power switch (9) to the “OFF” position.
2. Press and hold the “2” preset temperature (1) while switching the power switch (9) to the “ON” position.
To Change the Display to °C:
1. Switch the power switch (9) to the “OFF” position.
2. Press and hold the “3” preset temperature (1) while switching the power switch (9) to the “ON” position.
Setting the Set Point Temperature:
1. To set the temperature press and release the select/set knob (5). The decimal point in the display (2) will fl ash.
2. Rotate the select/set knob (5) to reach desired temperature is displayed. Rotating clockwise increases the setting,
rotating counterclockwise decreases the setting.
3. Once the desired setting is reached press the select/set knob (5) a second time.
Note: the unit will automatically accept the displayed set point approximately 10 seconds of inactivity, even if the
select/set knob was not pressed.
4. Allow the water to preheat completely before adding food product.
Monitor water level when adding, removing and heating food product. The water level should be between 1” and 2”
(25 mm - 50 mm) from the top of the bath or vessel. Never allow the water level to drop below the water pump outlet
during operation.
User-Defi ned Preset Temperature:
1. To set user defi ned preset temperatures: With the unit “ON” press the desired preset temperature button, 1, 2, or 3. A
decimal on the display (2) begins to blink and recalls the previous setting.
2. Rotate the select/set knob (5) until the desired temperature is displayed. Once the desired setting is reached press
the select/set knob (5) a second time. Press the desired preset temperature (1) button to save the temperature to that
button.
3. Allow the water to preheat before adding food product.
4. Monitor water level when adding, removing and heating food product. The water level should be between 1” and 2”
(25 mm - 50 mm) from the top of the bath or vessel.
Control Lockout Feature:
This feature enables the user to lock all controls on the controller. While the feature is activated, the unit will remain running
at the current settings.
1. Press and hold the select/set knob (5) until display (2) shows “LLo” (about 10 seconds) then let go. When locked, the
set point decimal point will not fl ash.
2. Press and hold the select/set knob (5) again, until the display (2) shows “LLo” (about 10 seconds) then let go to unlock
the controls. Once unlocked, the display (2) will show “CAN”.
Reset Button:
Should the water level drop below the heater the safety thermostat will activate and disconnect power from the heater and
pump. The display (2) will show “FLt 3”. Allow to cool and press the reset button (7).
Water Pump Outlet
Loading ...
Loading ...
Loading ...