Loading ...
2
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following:
1. Read all instructions.
2. This appliance is not intended for use by persons with reduced physical,
sensory, or mental capabilities, or lack of experience and knowledge, unless
they are closely supervised and instructed concerning use of the appliance by
a person responsible for their safety.
3. This appliance shall not be used by children. Keep the appliance and its cord
out of reach of children.
4. Close supervision is necessary when any appliance is used near children.
Children should be supervised to ensure that they do not play with the
appliance.
5. To protect against risk of electrical shock, do not put cord, plug, base, or
motor in water or other liquid.
6. Turn the appliance OFF (
), then unplug from outlet when not in use, before
putting on or taking off parts, and before cleaning. To unplug, grasp the plug
and pull from the outlet. Never pull from the power cord.
7. Normal operating cycle of blender/mill cycle is 2 minutes of on time. Allow
1 minute off period between each maximum cycle.
8. Avoid contact with moving parts.
9. Do not operate any appliance with a damaged supply cord or plug, or after
the appliance malfunctions or has been dropped or damaged in any manner.
Supply cord replacement and repairs must be conducted by the manufacturer,
its service agent, or similarly qualified persons in order to avoid a hazard. Call
the provided customer service number for information on examination, repair,
or adjustment.
10. The use of attachments, including canning jars, not recommended or sold by
the appliance manufacturer may cause a risk of injury to persons.
11. Do not use outdoors.
12. Do not let cord hang over edge of table or counter or touch hot surfaces,
including stove.
13. Do not place on or near a hot gas or electric burner, or in a heated oven.
14. Keep hands and utensils, other than the tamper provided, out of container
while blending to reduce the risk of severe injury to persons or damage to
the blender. The cover must remain in place when using the tamper through
the cover opening. A scraper may be used but must be used only when the
blender is not running.
15. Blades are sharp; handle carefully—especially when assembling, disassembling,
emptying or cleaning blender jar.
16. Do not use a broken, chipped, or cracked jar.
17. Do not use broken, cracked, or loose cutting blade assembly.
18. Always operate appliance with lid in place. Remove filler cap only for adding
ingredients.
19. Do not run a soup cycle unless blender/mill has fully cooled to room
temperature.
20. When blending hot liquids in the open top blender jar, remove center filler
cap and close any edge lid opening intended for pouring. To prevent possible
burns: Do not exceed the 2-cup (473-ml) level. Hot liquids may push off lid
during blending; therefore, with the protection of an oven mitt or thick towel,
place one hand on top of the lid, keep exposed skin away from the lid, and
start blending at lowest speed.
21. Be careful if hot liquid is poured into the jar as it can be ejected out of the
appliance due to sudden steaming.
22. Do not leave appliance unattended while it is operating.
23. Check that the appliance is OFF ( ) before plugging cord into wall outlet. To
disconnect, turn the control to OFF ( ); then remove plug from wall outlet.
To unplug, grasp the plug and pull from the outlet. Never pull from the power
cord.
24. Do not use appliance for other than intended purpose.
25. CAUTION! In order to avoid a hazard due to inadvertent resetting of the
thermal cut-off, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
SAVE THESE INSTRUCTIONS
Loading ...
Loading ...
Loading ...