Loading ...
Installation instructions
Minimum Clearance Other Than Alcove or Closet Installation I
Minimum clearance to combustible sm'faces and for air opening are: 0 in. clearance both sides and 1 in. rear. Consideration
_or installation and service. !
[] PREPARING FOR INSTALLATION [] ELECTRICAL CONNECTION
OF NEW DRYER iNFORMATiON
EXTERNAL
DUCT
OPENING
OR
DUCTCLAMP
DUCTTAPEOR
DUCTCLAMP
4"METALDUCT
TIP: Install your dryer before installing your washer.
This will allow better access when installing dryer exhaust.
REMOVING LiNT FROM WALL
EXHAUST OPENING
WALL
CHECKTHATEXHAUST
tHOODDAMPEROPENS
ANDCLOSESFREELY.
TILTTHEDRYERSIDEWAYS
ANDREMOVETHEFOAM
SHIPPINGPADSBY
PULLINGATTHESIDES
ANDBREAKINGTHEM
AWAYFROMTHEDRYER
LEGS,BESURETO
REMOVEALLOFTHE
FOAMPIECESAROUND
THELEGS.
INTERNALDUCT
OPENING...._
WARNING - TO REDUCE THE RISK OF
FIRE_ ELECTRICAL SHOCK AND PERSONAL
INJURY:
- DO NOT USE AN EXTENSION CORD OR AN
ADAPTER PLUG WITH THIS APPLIANCE.
Dryer must be electrically grounded in accordance with
local codes and ordinances, or in the absence of local
codes, in accordance with the NATIONAL ELECTRI-
CAL CODE, ANSI/NFPA NO. 70.
ELECTRICAL REQUIREMENTS
This dryer must be comlected to an individual branch circuit,
protected by the required time-delay fuses or circuit breakers. A
four or three-wire, single phase, 120/240V or 120/208V, 60Hz,
30 amp circuit is required.
If the electric supply does not meet the above specifications, then
call a licensed electrician.
GROUNDING iNSTRUCTiONS
This dryer must be connected to a grounded metal, permanent
wiring system, or an equipment-grounding conductor must be run
with the circuit conductors and connected to the equipment-
grounding terminal on the appliance.
CONNECTING DRYER USING 4-WIRE
CONNECTION (MUST BE USED FOR
MOBILE HOME INSTALLATION)
NOTES: Since January 1,1996,the National Electric code requires
that the new constructions utilize a 4-wire connection to
an electric dryer
WARNUNG:Only a 4-conductor cord shall be used when the
appliance is installed in a location where grounding through the
neutral conductor is prohibited. Grounding through the neutral is
prohibited for the new branch-circuit installations, mobile homes
recreational vehicles, and areas where local codes prohibit
grounding through the neutral conduction.
REMOVEGROUNDSTRAP
ANDDISCARD.KEEPGREEN
HOT_"_,
GROUNDSCREW WIRE RELOCATEGREEN
_'_-... GROUNDSCREW
HERE
GREENOR
J
3/4",UL
HOT RECOGNIZED
WIRE STRAINRELIEF
4#10AWGMINIMUMCOPPER
COVER CONDUCTORS OR120/240V30A POWER
SUPPLYCORDKITMARKEDFORUSE
WiTHDRYERS&PROVIDEDWITH
CLOSED LOOPOR SPADETERMINALS
2 WiTHUPTURNEDENDS(NOTSUPPLIED}.
Loading ...
Loading ...
Loading ...