Loading ...
Loading ...
Loading ...
4. Cut the plastic tie holding the Upright Wire Harness (96) in
the right Upright (69). Have a second person hold the
Handrails (66) near the Uprights as shown. Connect the
Upright Wire Harness (98) to the wire harness extending
from the Console Base (81). Insert the connectors and the
Upright Wire Harness into the hole in the right Upright.
Set the Handrails (66) on the Updghts (69), being careful
not to pinch the Upright Wire Harness (98).
5. Insert two Handrail Bolts (78) with Handrail Washers (77)
into the right Upright (69) and the right Handrail (66). Be
careful not to pinch the wires. Next, liftthe right
Handrail (66) slightlyand align the Boltswiththe holesin
the Handrail.Thread the Boltsintothe Handrail, Do not
tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (78).
6. Make sure that all parts are properly tightened before
you use the treadmill. Place a mat beneath the tread-
mill to protect the floor. For your benefit, familiarize
yourself with the information on pages 27 and 28,
78
If you purchase the optional chest pulse sensor (see
page 24), follow the steps below to install the receiver
and the short jumper wire included with the chest pulse
sensor.
1. Make sure that the power cord is unplugged. Remove
the indicatedscrewsfromthe ConsoleBack(A).
Important: The screws may be different lengths. Keep
track of which screws were removed from which holes.
Removethe ConsoleBack.
2. Peel the paper offthe pad on the bottom of the Receiver
(B). Turn the Receiver so the cylinder is on the side
shown, and press the Receiver intothe bottomofthe
ConsoleBase (D) in the indicatedlocation.
3. Connect the included Short Jumper Wire (E) to the wire on
the Receiver (B). Connect the other end of the Short
Jumper Wire to the PLS2 jack on the back of the Console
(C). If there is a wire already plugged into the PLS2 jack,
unplug it. Note: The other wires included with the receiver
may be discarded. The Wire Tie can be used to tie wires, if
needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console (C) with the screws. Important: If
the screws are not put back into the same holes from
which they were removed, the Console will be dam-
aged.
Screws
C
\
\
PLS2
Jack
7
Loading ...
Loading ...
Loading ...