Loading ...
Loading ...
Loading ...
(152,1)
北米Model "A8330BE-A" EDITED: 2022/ 7/ 26
! Rear gate drop prevention function
S02AJ0104
The rear gate is lowered by the weight of
snow and such, an electronic chirp will
sound and the rear gate drop prevention
function will apply braking to the rear gate
so that it prevents a rapid closure of the
rear gate.
NOTE
If there is snow on the rear gate, only
use the power rear gate function after
removing the snow.
! Selecting audible signal operation
S02AJ0109
Using an electronic chirp, the power rear
gate will give you an audible signal before
starting its operation. If desired, the audi-
ble signal can be turned off by a SUBARU
dealer. Consult your SUBARU dealer for
details.
For models with “keyless access with
push-button start system”, you can turn
the audible signal off by operating the
combination meter display (color LCD).
For details, refer to “Keyless Entry Sys-
tem” �P197.
The ON/OFF setting of the audible signal
also works as the audible signal settings
for the “remote keyless entry system” and
the “keyless access with push-button start
system”. However, for the warning chime
such as that caused by “Reverse function”
�P149 or “Rear gate drop prevention
function” �P150, it cannot be set as non-
operational.
! Initialization of power rear gate
S02AJ0112
If the power rear gate detects some
abnormality while operating, an electronic
chirp will sound and the power rear gate
operation will be automatically stopped in
either opening or closing position. In this
case, the system needs to be initialized in
the following order to restart the function
properly.
! If the power rear gate is closed
S02AJ011201
1. Keep pressing the rear gate opener
button until it is unlocked (for approxi-
mately 5 seconds) and lift up the rear
gate.
2. Pull down the rear gate until it starts to
close automatically. The system will be
initialized once the gate is fully closed.
3. Operate the power rear gate and check
that the function operates properly.
! If the power rear gate is opened
S02AJ011202
1. Pull down the rear gate until it starts to
close automatically. The system will be
initialized once the gate is fully closed.
If the rear gate will not close comple-
tely, keep pressing the rear gate open-
er button for approximately 5 seconds
and pull down the rear gate.
2. Operate the power rear gate and check
that the function operates properly.
CAUTION
If the power rear gate function does
not operate properly, have your
vehicle checked by SUBARU dealer.
Rear gate
150
Loading ...
Loading ...
Loading ...