Loading ...
9
Please note:
This symbol indicates recommendations and important
information for the user.
- Always use the appliance in an upright position.
- The use of extension leads is not recommended.
However if they cannot be avoided, follow the instruc-
tions accompanying the extension lead and never
exceed the power limit marked on the extension.
- The heater must be positioned at least 50 cm from furni-
ture or other objects.
- Do not use the appliance in rooms with a oor area of
less than 4m
2
.
- Before putting the appliance away, make sure it is com-
pletely o and unplugged from the mains socket. Wrap
the cable around the base.
Do not store in dusty atmospheres.
- Do not rest anything on the appliance.
- Do not use the appliance to dry laundry. Do not obstruct
the air intake and outlet grilles (danger of overheating).
- Do not use the appliance near walls, furniture, curtains,
etc.
Safety functions
- Safety device: the appliance is tted with a safety
device which switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the mains socket for
a few minutes, remove the cause of overheating then
plug in again.
If the appliance doesn't work please contact the
De'Longhi Customer Service.
- Tip over safety device: a tip over safety device turns
the appliance o if it falls over or is positioned inappro-
priately in such a way as to jeopardise safety.
The appliance emits a beep and a dot ashes on the di-
splay. The appliance resumes operation a few seconds
after being placed in an upright position again.
Disposing of the appliance
The appliance must not be disposed of with hou-
sehold waste, but taken to an authorised waste se-
paration and recycling centre.
INTRODUCTION
Thank you for choosing a De’Longhi product.
Please take a few minutes to read these instructions.
This will avoid all risks and damage to the appliance.
DESCRIPTION
A ON/STAND-BY button
B +/- Adjustment buttons
C Oscillation button
D “ECO PLUS” function button
E Timer button
F MODE button (for selecting the operating mode)
G Power indicator light
H Back cover with lter
I Receiver for remote control (certain models only)
USE
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.
Electrical connection
- Before plugging the appliance into the mains socket,
check that the mains power supply corresponds to the
value indicated on the rating plate and that the mains
power supply is adequate for the load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/
EEC ON RADIO INTERFERENCE SUPPRESSION.
Operation and use
- Connect the appliance to the power outlet.
- The appliance emits a beep and the power indicator
light (G) also comes on and remains lit while power to
the appliance is on. The appliance goes into STAND-BY.
- Press the ON/STAND-BY button (A) to turn on the
appliance. It will begin to heat with the predened
settings.
- Press the MODE button (F) to select one of the following
functions available:
l
Ventilation
In this operating mode only the fan operates, so the
appliance does not heat the room.
l
Anti-freeze
In this operating mode the appliance keeps the room at
a temperature of 7°C to prevent freezing temperatures.
l
Heating 1 and Heating 2
In this operating mode you can set the desired
temperature by pressing the + and - adjustment
buttons (B).
- Heating 1 (minimum power level):
The appliance operates at the minimum power, reducing
noise and energy consumption to the minimum.
- Heating 2 (maximum power level):
Loading ...
Loading ...