Loading ...
Loading ...
Loading ...
When the ambient room temperature is 25°C, a setting
of half way between ‘Off’ and ‘Colder’ recommended.
When you change temperature settings, make small
adjustments and wait 24 hours before assessing whether
you need to make further changes.
WIM1200 and WIM1400
Starting up and temperature regulation (WRM2400)
• Insert the product electrical plug into power-point.
When the refrigerator door is opened, the internal light
switches on. When the refrigerator is in its final position,
wait 5 minutes before switching it on. Do not store
anything in the refrigerator until the temperature is cold
enough.
• The temperature control knob is located on the top
right-hand side of the compartment
• When the control knob is turned to the off position, this
will switch the cooling off.
• The recommended operating position is between
“warm” and coldest” for most weather conditions and
ensures the temperature will not get below zero in the
refrigerator.
• At settings “Coldest” to “Freezing”, some areas of the
product may get below zero which is good for meat
and fish, but may be problematic for leafy vegetables,
carbonated drinks and similar foodstuffs. These settings
are for special usage short term freezing
WARNING
IMPORTANT
Normally we advise you to select a setting mid-range
between warm and coldest, and then adjust the
temperature up or down for your specific needs and
ambient conditions. Turning the knob to a colder setting
will consume more energy.
WARNING
IMPORTANT
High ambient temperatures (e.g. hot summer days)
with a colder setting may require the compressor to run
continuously in order to maintain the low temperature
inside.
10 INITIAL START-UP
INITIAL START-UP – FRIDGES
Refrigerator models WRM1400 & WRM2400 have been
fitted with a 'wet wall' evaporator which is positioned
behind the rear liner. The rear liner will, at times be wet
or appear frosted. This is normal and demonstrates that
the refrigerator is functioning correctly. This product is
designed to operate on a power supply of 220/240 volts
50Hz. Connect to a separate power point with a correctly
earthed three pin socket. Do not use double adaptors.
Controlling the temperature in your refrigerator
Refrigerators work by transferring heat from the food
inside to the outside air. This operation makes the back
and sides of the refrigerator (particularly at start-up)
feel warm – which is normal. Make sure you fully close
the refrigerator door after loading or removing food. If
the door is left partially open, a heavy frost will coat the
inside of the ice box. Ensure shelves are pushed back
completely to prevent them holding the door open.
If the unit is unplugged, power lost or turned off, you
must wait 3 to 5 minutes before restarting the unit. If
you attempt to restart the unit before this time delay, the
refrigerator will not start.
When the thermostat is turned to it’s lowest setting
and past the point of resistance, the appliance will not
operate.
WARNING
WARNING
Power is still supplied to the appliance.
Condensation caused
by the cooling plate
Turn the control knob clockwise to turn the appliance on.
Rotating clockwise will make the appliance colder.
For all models, ‘Less Cold’ corresponds to the warmest
temperature while ‘Colder’ the coldest.
Adjusting the control knobs of WIM1000 amd WIM1200
will adjust the temperature in both the fridge and freezer
compartments.
When the ambient room temperature is 16°C, a setting
of half way between ‘Less Cold’ and ‘Off’ recommended.
Bulb (inside)
Lampshade
Thermostat knob
WRM2400
Coldest
Cold
WIM1000
Less Cold
Off
Colder
Loading ...
Loading ...
Loading ...