Loading ...
Loading ...
Loading ...
I ENGLISHI
Troubleshooting
If you run into any problem using the camcorder, use the following table to troubleshoot the probtem.
If these instructions do not allow you to soive the problem, take a note of:
• The model and serial number marked on the bottom of the camcorder.
• Your warranty, if applicable.
Then contact your nearest authorized service center.
Symptom - Explanation/Solution
You cannot switch the • Check the battery pack (see page 23)
camcorder on. or the AC power adapter. (see page 22)
Start/Stop does not • Check the POWER, set it to CAMERA.
operate while recording • You have reached the end of the cassette.
• Check the record protection tab on the cassette. (see page 26)
The camcorder goes • You have leftthe camcorder set to STANDBY
off automatically, for more than 5 minutes wJthout using it.(see page 28)
• The battery pack is fully used up. (see page 25)
The battery pack is • The atmospheric temperature Jstoo low. (see page 25)
quickly exhausted. • The battery pack has not been charged fulty.(see page 23)
• The battery pack is completely dead, and cannot be recharged.
Use another battery pack.
You cannot eject the • The battery pack is fulty used up.
cassette from the • A mechanical fault might have occurred. (see page 63)
compartment.
The DATE/TIME indicator • The lithJumbattery is not installed or is fully used up.
flashes more than 2 times (see page 21)
when you set the
camcorder to CAMERA.
The playback picture • The video heads might be dirty. (see page 61)
is poor.
You cannot operate any • A mechanical fault might have occurred (see page 63).
functions on the camcorder.
Loading ...
Loading ...
Loading ...