Loading ...
Loading ...
Loading ...
25
CHANGING THE FILTER
Do not use with water that is microbiologically
unsafeorofunknownqualitywithoutadequate
disinfection before or after the system. Systems
certiedforcystreductionmaybeusedon
disinfectedwatersthatmaycontainlterablecysts.
Test & certication results:
Rated Capacity - 125 gallons/473 liters for
PureSource Ultra II
TM
iceandwaterlter
Ratedserviceow-.65gallonsperminute
Operating Temp: Min. 33°F, Max. 100°F
Maximum Rated Pressure - 100 pounds per
squareinch
Recommended Minimum Operating
Pressure:30poundspersquareinch
The PureSource Ultra II
TM
iceandwaterltersystemis
testedandcertiedtoNSF/ANSI
Standards 42, 53 and 401 for the
reductionofclaimsspeciedon
the performance data sheet.
More about your Advanced
Water Filter
To replace your PureSource Ultra II
TM
water lter:
It is not necessary to turn the water supply off
tochangethelter.Bereadytowipeupany
small amounts of water released during the
lterreplacement.
1 Turn Off the ice maker power switch.
2 Removetheoldlterbyrotatingitcounter-
clockwise (to the left) 90 degrees to release it.
3 Slidetheoldltercartridgestraightoutof
the housing and discard it.
4 Unpackagethenewltercartridge.Slideit
intothelterhousingasfarasitwillgowith
the grip end horizontal.
5 Pushlightlyinwardonthelterwhilerotating
itclockwise(totheright).Thelterwillthen
pull itself inward as it is rotated. Rotate the
lter90degreesuntilitstopsandthegrip
end is vertical. You may be able to feel a very
lightclickasthelterlocksintoplace.
6 Press a drinking glass against the water
dispenser while checking for any leaks at
thelterhousing.Anyspurtsandsputters
that occur as the system purges air out of
the dispenser system are normal.
7 Continue dispensing water for 3-4 minutes
oruntil1.5gallonsofwaterhasowed
through the system. You will likely need to
emptyandrellyourglassseveraltimes.
8 Turn On the ice maker.
9 Press and hold the Water Filter reset
button on the control panel for three
seconds. When the display changes from
Red to Green, the status has been reset.
Loading ...
Loading ...
Loading ...