Loading ...
Loading ...
Loading ...
9
the instructions on the bottle. Please call 1-800-547-3888 to order Bacteriostat
Treatment, reference part number 1970.
1. Turn off unit completely and unplug from outlet.
2. Lift out the water bottles and the power pack.
3. Carry bottles and base to cleaning basin. Remove and dispose of used wick.
Empty the water from the reservoir and water bottles. Fill reservoir and each
water bottle ½ full with water and add 8 oz. (1 cup) of white vinegar to each.
Let stand 20 minutes. Then empty solution.
4. Dampen a soft cloth with white vinegar and wipe out reservoir to remove scale.
Rinse the water bottles and reservoir thoroughly with fresh water to remove
scale and cleaning solution before disinfecting.
DISINFECTING UNIT
5. Fill each water bottle and reservoir ½ full with water and add 1 teaspoon of
bleach to each. Wipe cabinet and bottle surfaces with this solution. Let
solution stay for 20 minutes, then rinse with water until bleach smell is gone.
Dry with clean cloth. The outside of the unit and water bottles may be wiped
down with a soft cloth dampened with fresh water.
6. Refill unit and re-assemble per ASSEMBLY instructions.
SUMMER STORAGE
1. Clean unit as outlined in Care & Maintenance section.
2. Discard used wick and any water in the reservoir or bottles and allow to dry
thoroughly before storage. Do not store with water inside reservoir or bottles.
3. Do not store unit in an attic or other high-temperature area, as damage will
occur.
4. Install new filter at beginning of season.
TROUBLESHOOTING
Trouble
Probable Cause
Remedy
Digital display not
illuminated.
• No Power.
• Power button has not
been depressed.
• Check 120 volt power source.
• Press power button once to turn on.
Not enough humidity
• Humidity level is not set
high enough.
• Bottles are empty.
• Wick not absorbing
water
• Turn humidity level knob up.
• Increase fan speed.
• Fill humidifier with water.
• Replace wick
Fan running
continuously.
• Float is obstructed.
• Humidity level is set to
highest position
• Humidity level
has not reached the
desired level yet.
•
Free float from obstruction
.
• Setting the humidity to highest
position causes the fan to run
continuously. Adjust the level lower.
• Continue to run until desired
humidity level is achieved. This
may take up to 48 hours initially.
Poor evaporation of
water.
• CHECK FILTER
(CF)
message flashing.
• Mineral buildup on filter
(wick).
• Change to a fresh new wick
NOTE: Local water varies from area
to area and under certain conditions
minerals will build up more rapidly in
the wick.
• Unplug unit for 1-2 minutes to reset
CF function
Loading ...
Loading ...
Loading ...