Loading ...
Loading ...
Loading ...
10
|
ENGLISH
Using Your
Heavy Duty Steam Cleaner
FILLING BOILER
1. Place unit on a at, level surface.
2. Make sure illuminated On/Off Switch is turned to “Off” and grounded power cord is unplugged
from electrical outlet.
If unit has been in use, always use the following safety precautions before
removing the Boiler cap to add water:
•
Allow unit to cool for 20 minutes or until pressure gauge is at zero.
•
Press and hold Steam Trigger to release ALL remaining steam.
WARNING: Failure to follow these precautions may result in burns from escaping steam
when the Boiler Cap is removed.
3. Cautiously unscrew and remove Boiler Cap.
WARNING: Water may be hot.
4. Drain any water remaining inside Boiler.
NOTE: The Boiler should be emptied after each use – this will help minimize mineral
build-up and prevent over-lling.
5. Using the Fill Cup, ll the unit with 48 oz (1,420 ml) of water.
NOTE: In order to signicantly reduce mineral build-up and prolong the life of your
Heavy Duty Steam Cleaner, use of distilled or de-mineralized water in the unit is highly
recommended. Refer to Page 13 for more information about mineral build-up.
WARNING: Caution should always be used when pouring water into the Boiler. Do not
look directly down into ll hole when lling. Keep your free hand and any children or
pets at a safe distance.
6. Replace Boiler Cap, ensuring that it is screwed on tightly to prevent hot steam from escaping
and causing injury.
!
Loading ...
Loading ...
Loading ...