PKM F7-2B Einbau Backofen autark schwarz Glas 60cm

User Manual - Page 23

For F7-2B.

PDF File Manual, 51 pages, Read Online | Download pdf file

F7-2B photo
Loading ...
Loading ...
Loading ...
23
8. This appliance complies with the current European safety legislation. We do wish
to emphasize that this compliance does not negate the fact that the surfaces of
the appliance will become hot while operating and will retain and emit heat
even if it has stopped operating.
NOTICE
1. When you move the appliance, hold it at its base and lift it carefully. Keep the
appliance in an upright position.
2. Never use the door for moving the appliance as you will damage the hinges.
3. The appliance must be transported and installed by at least two persons.
4. When you unpack the appliance, you should take note of the position of every
part of the interior accessories in case you have to repack and transport it at a
later point of time.
5. Do not operate the appliance unless all components are installed properly.
6. Do not stand or lean on the base, the drawers, the doors etc of the appliance.
7. The air vents of the appliance or its built-in structure (if the appliance is suitable
for being built-in) must be completely open, unblocked and free of any kind of
dirt.
8. Do not put any heavy items onto the open door of the oven. Do not lean against
the open door of the oven as you will damage the hinges.
2. Installation
2.1 Unpacking and positioning
1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-protection.
3. Check that the appliance and the power cord are not visible damaged.
4. Do not install the appliance in a place where it may come in contact with water
or rain; otherwise, the insulation of the electrical system will be damaged.
5. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
6. Remove the complete packaging material (inside and outside the appliance)
before initial operation.
7. The nameplate is situated inside the appliance or at the back.
Loading ...
Loading ...
Loading ...