Loading ...
Loading ...
Loading ...
12
DESCALING THE ESPRESSO MACHINE
The descaling program enables simple and effective descaling of your Espresso Machine.
Descale the Espresso Machine regularly, but a minimum whenever the “Clean ( )” indicator
is blinking. The frequency of descaling depends on the hardness of the water in your region.
Therefore, it is important to program the Espresso Machine according to the water hardness
level of your location.
NOTE: The descaling process runs in 4 phases, takes approximately 10 minutes and
must be completed before next use. At any time during the descaling program you can
pause the cycle by pressing
button. And, resume too by pressing button.
SET UP OF GROUP HEAD DESCALING
IMPORTANT: Only use descaling solution intended for Espresso Machines.
1 2
Phase 1: Place a container (~ 17 ounces)
on the Drip Tray below the Group Head.
Press the Clean cycle ( ) button for 3
seconds or until Clean light is solid. Then,
press button to start rst phase of
decalcication cycle.
Start/Cancel ( ) will blink fast after
the rst phase is complete. Empty the
container.
2
Fill 8.5 ounces water and 4.25 ounces
descaling solution inside the Water Tank.
NOTE: The clean cycle is designed to
run as per the above mentioned water
and descaling solution volumes.
The cycle cannot be completed with
any less volume than mentioned above.
1
Water
Descaling
solution
CARE AND CLEANING
1 2
Phase 2: Place the container (~ 17 ounces)
below the Steam Wand. Then, press
button.
Start/Cancel ( )
and Water
Mode lights will blink fast after the second
phase is complete. Empty the container.
3
1 2
Phase 3: Place the container (
~ 17 ounces
)
below the Steam Wand. Empty, rinse and
refill the Water Tank with fresh water to Max
fill line. Replace the Water Tank. Press
button.
Start/Cancel ( ) will blink fast after the
third phase is complete. Empty the container.
4
W11312156C.indb 12W11312156C.indb 12 8/12/2020 7:43:42 PM8/12/2020 7:43:42 PM
Loading ...
Loading ...
Loading ...