Loading ...
Loading ...
Loading ...
Theoperationofanytractorcan resultinforeign objects thrown into
the eyes, which can result in severe eye damage. Always wear
safety glasses or eye shields while operating your tractor or
performing any adjustments or repairs. We recommend standard
safety glasses or a wide vision safety mask worn over spectacles.
HOWTO USEYOURTRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator
presence sensing switch. When engine
is running, any attempt by the operator to
leave the seat without first setting the
parking brake will shut off the engine.
1. Depress clutch/brake pedal all the
way down and hold.
2. Pull parking brake lever up and
release pressure from clutch/brake
pedal. Pedal should remain in brake
position. Make sure parking brake will
hold tractor secure.
C' . P,.ush-ln to -, Attachment Clutch
noKe, ul_sengagea° Switch Pull Out To
Th rottIe_"__.. _ _",/_,
Contro,,.__ _._
Brak<_-_-J_ _-_ _-IanitionX__._ /
Position _ _ J I<ey
Clut_h/._._._,,..__/-_ En.gaged"
Brake Pedal"_/"Dis_ngaged;'_ Position
=Drive" / Position Gear Shift
Position Height Lever
Adjustment Knob
STOPPING
MOWER BLADES -
• To stop mower blades, push attach-
ment clutch switch in to disengaged
position.
GROUND DRIVE -
• To stop ground drive, depress clutch/
brake pedal all the way down.
• Move gearshift lever to neutral (N)
position.
ENGINE -
• Move throttle control to slow position.
NOTE: Failure to move throttle control to
slow position to allow engine to idle
before stopping may cause engine to
"backfire".
• Turn ignition key to "STOP" position
and remove key. Always remove key
when leaving tractor to prevent
unauthorized use.
• Never use choke to stop engine.
IMPORTANT: Leaving the ignition switch
in any position other than "STOP" will
cause the battery to discharge and go
dead.
NOTE: Under certain conditions when
tractor is standing idle with the engine
running, hot engine exhaust gases may
cause "browning" of grass. To eliminate
this possibility, always stop engine when
stopping tractor on grass areas.
_kCAUTION" Always stop tractor
completely, as descnbed above, before
leaving the operator's position.
TO USE THROTTLE CONTROL
Always operate engine at full throttle.
• Operating engine at less than full
throttle reduces the battery charging
rate.
• Full throttle offers the best mower
performance.
TO USE CHOKE CONTROL
Use choke control whenever you are
starting a cold engine. Do not use to start
a warm engine.
• To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE FORWARD AND BACK-
WARD
The direction and speed of movement is
controlled by the gearshift lever.
1. Start tractor with clutch/brake pedal
depressed and gearshift lever in
neutral (N) position.
2. Move gearshift and range shift levers
to desired position.
3. Slowly release clutch/brake pedal to
start movement.
IMPORTANT: Bring tractor to a complete
stop before shifting or changing gears.
Failure to do so will shorten the useful life
of your transaxle.
TO ADJUST MOWER CUTTING HEIGHT
The cutting height is controlled by turning
the height adjustment knob in desired
direction.
• Turn knob clockwise (F_) to raise
cutting height.
12
Loading ...
Loading ...
Loading ...