Loading ...
Loading ...
Loading ...
4
REV 4 - 1709221030
L-C2-214
INSTALLATION & SETUP (cont.)
ASSEMBLY
1. Locate the crank handle (Fig. 4-1) packed inside the grill
enclosure.
2. Insert the threaded end of the crank handle through the hole
on the right of the grill face and into the nut on the frame as
shown.
3. Center the crank on the nut and begin cranking in a clockwise
direction until the threads have properly caught hold.
4. Close the door in the front panel and continue cranking until
the lifter begins to move upward inside the grill.
Note: The access door must be closed for the crank to raise
the lifter to the highest position.
5. Place both cooking grids with cut-outs toward the front as
shown in Fig. 4-2.
6. Install both shelves as indicated below.
RIGID SHELF ASSEMBLY
This grill comes with two (2) rigid shelves that must be
attached. These can be attached using the four (4) support
screws provided and a long Phillips-head screwdriver.
1. Hold the shelf inverted so that one of the corner holes
in the shelf lines up with the appropriate upper screw
hole in the grill.
2. Insert the screw (but do not tighten all the way) so that
the shelf can be easily rotated around the fi rst screw.
3. Line up the second corner hole in the shelf with the
remaining upper screw hole in the grill. Insert a screw
and tighten.
Note: You may lift the edge of the shelf upward to gain
better access during much of the tightening of this
screw.
4. Finally, insert the bottom screws on the left and right
side of the shelf and securely tighten all screws.
Detaching is the reverse process of above.
WARMING RACK (if equipped)
The warming rack (Fig. 4-4) is packed separately. To install the
warming rack, carefully insert the rack hangers into the two holes
in the back of the inner oven hood, then lower the front of the
rack to a level position.
To remove the warming rack, lift up on the front of the rack until
the rack hangers pull free from their supporting holes.
Shelf support screws
Fig. 4-3 View from under right shelf
Fig. 4-2 Install cooking grids
Fig. 4-1 Install crank
Crank
(Access door)
Close access
door when
cranking handle.
Fig. 4-4 Warming rack in place inside oven
Loading ...
Loading ...
Loading ...