Loading ...
Loading ...
Loading ...
8
Installation
Installation - Ducting version
After having choosen the vent option, proceed as
follows:
Remove the grease filters.
Remove the 2 lateral supports.
Remove the duct knockouts using a flat blade
screwdriver and a small hammer.
Use the screwdriver by knocking out the pannel in
similar fashion to a scalpel.
Take care of sharp edges.
Attach exhaust adaptor/damper over knockout
opening with two exhaust adaptor screws. Make
sure damper pivot is nearest to top/back edge of
hood.
Remove tape from damper flap.
NOTE: The exhaust adaptor/damper can be installed
up to 1 inch on either side of the hood center to
accommodate off-center ductwork. In extreme
offcenter
installations, one end of the duct connector
may need to be trimmed to clear the electrical cable
clamp.
Mark holes
Select the vent option that your installation will require
and proceed to that section:
Outside top exhaust
(Vertical duct– 3 1/4”x 10” Rectangular)
Use the diagram or the hood as a template and mark
the locations on the cabinet for ductwork, electrical
wiring and keyhole screw slots.
Loading ...
Loading ...
Loading ...