Loading ...
2
Blender Safety
IMPORTANT: This operation manual should be reviewed with all equipment operators as part of your
operator training program.
1. Read the Operation Manual before using blender.
Keep Operation Manual handy.
2. Plug into a grounded 3-prong outlet.
3. Do not remove ground prong.
4. Do not use an adapter.
5. Do not use an extension cord.
6. Disconnect power before cleaning or servicing.
7. To reduce risk of personal injury, unplug cord from
outlet when not in use and before putting on or
taking off parts.
8. To protect against electrical shock, do not immerse
cord, plug, or blender base in water or any other
liquid.
9. Do not spray the base with a high-pressure spray
gun.
10. Extreme caution must be used when moving an
appliance containing hot oil or other hot liquids.
11. Do not use appliance for other than intended use.
12. Not intended for use by or near children.
13. Children should be supervised to ensure that they
do not play with the appliance.
14. The appliance is not intended for use by persons
(including children) with reduced physical, sensory,
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
15.
The use of accessory attachments not recommended
by the appliance manufacturer may cause injuries.
16. To reduce risk of personal injury and to prevent
damage to blender or container and cutter assembly,
DO NOT insert utensils into blender container while
operating blender.
17. Do not store any kitchen utensils in the container
because the blender would be damaged if
inadvertently turned on.
18. To prevent possibility of serious personal injury,
keep hands out of blender container while operating
blender. Always operate blender with container lid in
place.
19. Avoid contacting moving parts.
20. Blades are sharp. Handle carefully.
21. If cutter assembly blades are loose, discontinue use
immediately and replace cutter assembly. Do not
attempt to repair or tighten blades.
22. Inspect container and cutter assembly daily. Do not
use broken, chipped, or cracked container. Check
cutter for wear, nicks, or broken blades. Do not use
broken or cracked cutting blades.
23. Do not use outdoors.
24. This appliance is intended for short periods of
operation, with a rated operating time of 2 minutes.
25. Do not leave blender unattended while it is operating.
26. To prevent damage to blender, container, or cutter
assembly, DO NOT move or shake blender while in
operation.
27. When blending hot liquids, remove center-piece of
two-piece lid. Hot liquids may push lid off jar during
blending. To prevent possible burns: Do not fill
blender jar beyond the 1 quart (1 liter) level. With the
protection of an oven mitt or thick towel, place one
hand on top of lid. Keep exposed skin away from lid.
Start blending at lowest speed.
28. Always operate blender with container lid in place.
29. Do not operate any appliance with a damaged
cord or plug or after the appliance malfunctions,
or is dropped or damaged in any manner. Call
the Technical Services number, 866-285-1087 or
910-693-4277, for instructions on examination, repair,
or electrical or mechanical adjustment.
IMPORTANT SAFETY INSTRUCTIONS
WARNING – When using electrical appliances, basic safety precautions should be followed,
including the following:
– SAVE THESE IN STRUC TIONS –
Cut Hazard
Always place lid on container when
blending.
Do not put hands, spoons, or other
utensils in container when blending.
Failure to follow these instructions can
result in broken bones, cuts, or other
injuries.
Electrical Shock Hazard
Disconnect power before
cleaning blender base.
Failure to follow these
instructions can result in
death or electrical shock.
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...
Loading ...