Loading ...
Loading ...
Loading ...
ASSEMBLY
LOCKING TABS
VACUUM TUBE ASSEMBLY
(Fig 4, 5, 6, & 7)
• Remove the blower tube from the engine.Page 6.
• Setthe unit,bloweroutletup,ona flat surface.Open the
vacuuminlet coveras follows:
- Inserta screwdriverintolatcharea.
- Gently twistthe tip of the screwdriverand open the
vacuum intet cover withyourotherhand.
, Holdopenvacuuminletcoverand alignthegrooveson the
uppervacuumtubewiththelockingtabsinsidethevacuum
inlet.Insertthe uppervacuumtube andturnclockwiseuntil
partssnaptogether.
• Assemble thevacuum tubes by aligning the slanted end
of the lower vacuum tube with the blower outlet as
shown. Push the two tubes together until they are snug.
NOTE; The bottom end of the lower vacuum tube is cut at
an angle. Make sure slanted end of vacuum tube is
aligned with blower outlet.
• To attach the vacuum bag, align the grooves on the
elbow tube with the locking tabs insidethe blower out-
let. Be sure to atign the dot on the elbow tube with the
dot on the blower housing, insert elbow tube into blow-
er outlet; twist elbow tube counterclockwise until parts
snap together,
• Adjust the vacuum bag atthe elbow tube to remove any
twists.
LATCH AREA
BLOWER OUTLET
AREA
VACUUM
INLET COVER
Figure 4
SLANTED
END
LOCKING TAB
UPPER VACUUM
TUBE
VACUUM INLET
LOWER.VACUUM
TUBE VACUUM INLET COVER
Figure 5
ELBOW TUBE
TO THE
RIGHT
GROOVE
Figure 6
VACUUM BAG! (
Figure 7
SHOULDER STRAP ADJUSTMENT (Fig 7)
• With your left hand hold the unit in an uprightposition,
supporting the lower vacuum tube on the ground.
Make sure the blower outlet and vacuum bag are
positionedon your right-handside.
• Place vacuum bag strap around your back and over
your Ieft shoulder. Snap vacuum bag hook onto the
strap retainer inthe top handle.
• Extend your right arm toward the rear of the vacuum
bag,
• Adjust the shoulder strap until the vacuum bag/shoulder
strap seam liesbetween your thumb and index finger.
• Make sure the shoulder strap is adjusted to allow a
free flow of air from the elbow tube. If the vacuum bag
is kinked, the unit will not operate properly.
BLOWER CONVERSION
• Stop the engine. Allow the engine tocool.
- Remove the vacuum tubes and vacuum bag assembly,
- Secure the vacuum inlet cover. Make sure that the
latch on the vacuum inlet cover is securely fastened.
• Reinstall the blower tubes as shown in the "Blower
Tube Assembly" section.
CHECK LIST
• Check all fasteners. Make sure they are tight and there
are no loose parts.
-7-
Loading ...
Loading ...
Loading ...