Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
,="U,HL,_,
• Guide rope inside the pulley, then through pulley hole.
Figure 16.
• Wrap rope counterclockwise around the pulley ratchet
and tuck the loose end back under the rope, leaving
about a 1 inch tail next to the retainer rib. The end of
the rope should not go more than 1/4" past the end of
the retainer rib.
• Install and tighten the retainer screw/washer. Figure
16.
NOTE: Do not over tighten the retainer screw. Over tight-
ening the screw can cause the screw post to strip out.
Tighten the screw until the bottom of the washer either
(1) is snug against the rope or (2) contacts the top of the
screw post.
o Pull the rope tightly around the pulley ratchet.
° Slightly pull the rope to relieve the pressure on the hex
wrench. Remove the hex wrench and allow the rope to
rewind slowly.
• Reassemble the pulley housing to the engine. Tighten
screws securely.
NOTE; Be sure the rubber o-ring is installed onto the
pulley housing. See Figure 14.
CLEAN/REPLACE FUEL FILTER (Fig 23 & 24)
• Runfuel tankdry offuel beforeproceedingwiththis step.
• Removefuel capand allow ittohangtoside ofmotor.
• Using a small pairof needlenose pliers, grasp fuel cap
retainer,holdingitintankopeningand pull out.
• With cap out of tank, use a small section of bent wire
similar to that shownin the illustrationto catch fuel line
and slowly pull from tank. When fuet filter appears in
opening,graspwithfingers andremovefrom tank.
• Oncefilter isout oftank, holdfuel linecloseto fuel filter.
Remove fuel filter by twistingand pulling at the same
time.
• To cleanfuel filter, submerge inwarm soapywater for 10
minutes. (We recommend a very light mixture of dish
washing liquid.) Then agitate until filter is clean, rinse
thoroughly inwarmwater,air dry.
, reverseprocessfor installation.
• To replacefuel filter, usesame procedure,but installnew
filter.
PULLEY RATCHET
ROPE
RETAINER
SCREW/WASHER
ROPE TAIL
RETAINER
Figure 21
• Align the hole in the impeller with the impeller shaft,
making sure the flat sides are aligned.
NOTE: When re-assembling the impeller housing to the
engine shroud, be sure not to over tighten screws. Over
tightening the screws can strip out the impellerhousing,
• Assemble parts by reversing the first four steps under
"Repair OrReplace Starter Rope'.
U I I I ! I l I 1 l I_ 1] FLATSlOEOF
,, __ ,.... ,,,, _ IMPELLER SHAFT
SIDEOF.OLE
. i ...... '
Figure 22
RETAINER
Figure 23
FUEL CAP
BENT WIRE !
',FUEL UNE FUEL
FILTER/ FIL'rER"i_
BARREL NECK
Figure 24
-18-
Loading ...
Loading ...
Loading ...