Loading ...
Loading ...
Loading ...
Page 54 of 66
SMELL OF GAS WHILE COOKING:
IF YOU SMELL GAS WHILE THE GRILL IS OPERATING, IMMEDIATELY TURN OFF ALL
BURNERS AND SHUT OFF THE MAIN FUEL SUPPLY.
•
Perform a leak test (See INDEX: “Leal Test Procedure” for further details).
•
Check for blockages (See INDEX: “Caring for Your Grill” for further details).
GRILL WON’T GET TO TEMPERATURE:
If the unit does not get to operating temperature within 30 minutes of starting, the
burners may not be getting sufficient gas flow.
•
If possible, re-orient the oven to ensure that excessive wind is not affecting performance.
•
Leaving the burner valve open before opening the cylinder valve may cause the flow
control device to activate. Close all valves and follow the lighting procedures
(See
INDEX: “Lighting Your Grill” for further details).
.
•
LP cylinder does not have enough gas to deliver proper pressure. Change the tank if
necessary. In some situations, in cold ambient temperatures, an LP cylinder will ice up,
creating a drop in pressure. If this happens, turn off the tank and let it warm up before
trying again. A full tank is less likely to ice up than a tank that is less than half full.
•
Check that the Main gas supply is fully on and not partially opened.
•
Have the line pressure checked by a qualified technician (See INDEX: “Gas Connections” for
further details.)
•
Orifices are clear and not clogged. A clogged orifice creates a dangerous situation. Do
not use the grill until the issue has been resolved (
See INDEX: “Caring for Your Grill” for
further details).
THE GRILL IS PRODUCING A LOT OF SMOKE:
This is typically caused by something oily getting onto the cooking grates. If this
happens, the only thing you can do is to try and burn it off. Use caution when doing
this as the grill will get extremely hot very fast, so never leave it unattended when
trying to burn off any oily substances. Burnt cheese or other solids can be scraped or
brushed off the cooking grates.
THE LIGHTS WON’T ILLUMINATE:
If the grill/side burner were purchased with an optional light package and the lights won’t
illuminate, try the following:
Loading ...
Loading ...
Loading ...