Loading ...
Loading ...
Loading ...
Page 36 of 66
CONNECTION TO AC
Installation requires an outdoor 120VAC 15A GFI (Ground Fault Interrupter) electrical outlet
adjacent to the appliance. The GFI outlet features an internal breaker that reduces shock
hazard. This type of outlet should be installed by a qualified electrician either inside the island
enclosure for built-in units, or near the location where a free-standing unit will be used.
For built-in grills, the supplied 12VDC should be installed below the grill within the cabinet
enclosure. Select a location where the transformer is protected against water, heat and physical
damage.
When installing the transformer to the grill be careful to prevent the wiring and transformer
from contacting any hot surfaces behind or below the grill. It is recommended that the
transformer be located below the grill in a readily accessible location. Be sure to provide
adequate access to facilitate service if the transformer or connections should need future
maintenance.
If the electrical system fails to operate, a connection may have come loose in shipping or the
GFI may have tripped, requiring a reset.
Warning! Natural Hazard - Spiders
Spiders and other insects are
attracted by the smell of gas and
could make webs or nests in the
burners. This could partially or
completely block the flow of gas
through the venturis and is
indicated by a smoky, yellow
flame, and/or a burner that is
difficult or impossible to light.
Ultimately, it may cause the gas
to burn outside the venturis,
which can seriously damage your
grill. If this happens, immediately
shut off the propane at the
cylinder, or natural gas at the main shut-off valve. To prevent and/or correct this
occurrence, periodically check the venturis for obstructions by inserting a pipe cleaner
or flexible wire through the air inlet of the burner and twisting it. Ensure venturi tubes
are properly “seated” over the orifices after cleaning.
Loading ...
Loading ...
Loading ...